VOLVO
ADM-0006 - Pump, additive. Signal missing
System
Additivdoseringsmodul (ADM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
4 modellerC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Vis modeller per årsmodell og motor (9)
- Volvo C30 (2007–2013)2007–2010Kun motor: D4164T, D4204T
- Volvo C30 (2007–2013)2011Kun motor: D4164T
- Volvo C70 (2006–2013)2008–2010Kun motor: D4204T
- Volvo S40 (2004–2013)2005–2006Kun motor: D4164T, D4204T, D4204T2
- Volvo S40 (2004–2013)2007–2010Kun motor: D4164T, D4204T
- Volvo S40 (2004–2013)2011Kun motor: D4164T
- Volvo V50 (2004–2013)2005–2006Kun motor: D4164T, D4204T, D4204T2
- Volvo V50 (2004–2013)2007–2010Kun motor: D4164T, D4204T
- Volvo V50 (2004–2013)2011Kun motor: D4164T
Hva betyr feilkoden?
The additive dosing module (ADM) has found an open circuit in the wiring to the additive pump. Without a signal from the pump circuit, additive cannot be dosed, and the fault shows up as the emissions warning lamp. The pump is built into the additive tank, so it is not replaced separately.
Mulige årsaker
- Poor contact, resistance or corrosion at the terminals
- Break in the wiring to the additive pump
- Damaged additive pump
- Damaged additive dosing module (ADM)
Hva du kan gjøre
- 1Check the connector at the additive tank for looseness, contact resistance and oxidation
- 2Look for breaks in the wiring to the pump, especially where it enters the tank
- 3Clear the code and check whether it returns
- 4If the code returns with no visible cause, the additive tank may need replacing because the pump is inside it
- 5If the fault remains, have a workshop with diagnostic equipment check the pump and the module
Symptomer du kan merke1
- Emissions warning lamp lit
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.