VOLVO
BCM-0093 - Angle of lean sensor. Faulty signal
System
Bremsestyring (BCM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
5 modellerS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Vis modeller per årsmodell og motor (11)
- Volvo S60 (2001–2009)2005–2009
- Volvo S80 (1999–2006)2005–2006
- Volvo V70 (2000–2008)2005–2008
- Volvo V70 XC / XC70 (2001–2007)2005–2007
- Volvo XC90 (2003–)2003–2004, 2015
- Volvo XC90 (2003–)2005–2006Alle motorer unntatt: B8444S
- Volvo XC90 (2003–)2007Kun motor: B5254T2, D5244T4
- Volvo XC90 (2003–)2008–2010Alle motorer unntatt: B6324S, B8444S
- Volvo XC90 (2003–)2011Alle motorer unntatt: B6324S5, B8444S
- Volvo XC90 (2003–)2012Alle motorer unntatt: B6324S5
- Volvo XC90 (2003–)2013–2014Kun motor: B5254T9
Hva betyr feilkoden?
Applies only to cars fitted with DSTC and RSC. The lean angle sensor in the AYC sensor measures the car's lean from side to side and sends the value to the brake control module. The code is set when the signal is faulty, which is due to an open circuit or short to ground in the wiring or to an internal fault in the AYC sensor.
Mulige årsaker
- Open circuit or short to ground in the wiring to the AYC sensor
- Internal fault in the AYC sensor
Hva du kan gjøre
- 1Check the wiring between the connector and the AYC sensor for open circuits and short circuits to ground
- 2Read the lean angle sensor value with diagnostic equipment
- 3If the value is wrong, the AYC sensor may need replacing by a workshop
- 4The brake system is safety critical: do not replace the brake control module for this code, and do not work on the stability sensor yourself
Symptomer du kan merke3
- Anti-spin does not work
- Stability function does not work
- Anti-skid does not work
Hva feilen kan påvirke2
- Traction control (TC), stability control (SC) and active yaw control (AYC) are disabled
- Roll stability control (RSC) is disabled
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.