VOLVO
BCM-B11D408 - Low Speed Collision Mitigation By Braking Disabled. General Failure Information. Bus Signal / Message Failures
System
Bremsestyring (BCM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
2 modellerV40 (2013–), V40 Cross Country (2013–)
Vis modeller per årsmodell og motor (2)
Hva betyr feilkoden?
The automatic braking at low speed, which is part of the forward monitoring, has been switched off. The fault is caused by interference or communication faults on the CAN network, for example another module disturbing the network or braking requests arriving too often.
Mulige årsaker
- Short circuit between the CAN wires
- Open circuit in one of the CAN wires
- Internal fault in another control module on the same part of the CAN network
- Internal fault in the module
Hva du kan gjøre
- 1Read the codes in the other modules on the CAN network and deal with them first
- 2Check the CAN wiring and connectors with diagnostic equipment
- 3If the fault remains, have a workshop find which module is disturbing communication
- 4The brake system is safety critical: do not work on the brake system modules yourself, and have a workshop repair the fault
Symptomer du kan merke1
- Forward monitoring and automatic braking do not work
Hva feilen kan påvirke2
- Low speed automatic braking is disabled while the code is set
- The module stays switched off until the power supply is interrupted, and on a new start it tries to communicate again
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.