VOLVO
BCM-C006A01 - Multi-axis Acceleration Sensor. General Failure Information. General electrical failure
System
Bremsestyring (BCM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
9 modellerC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S80 (2007–), V50 (2004–2013), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Vis modeller per årsmodell og motor (14)
- Volvo C30 (2007–2013)2011–2013Kun motor: D4162T, D5204T, D5204T5
- Volvo C70 (2006–2013)2011Kun motor: D5204T, D5204T5
- Volvo C70 (2006–2013)2012–2013Alle motorer unntatt: B5254T7
- Volvo S40 (2004–2013)2011–2012Kun motor: D4162T, D5204T, D5204T5
- Volvo S80 (2007–)2007–2015
- Volvo V50 (2004–2013)2011–2012Kun motor: D4162T, D5204T, D5204T5
- Volvo V70 (2008–)2008–2015
- Volvo XC60 (2009–)2009–2012
- Volvo XC70 (2008–)2008–2015
- Volvo XC90 (2003–)2005–2006Kun motor: B8444S
- Volvo XC90 (2003–)2007–2010Kun motor: B6324S, B8444S
- Volvo XC90 (2003–)2011Kun motor: B6324S5, B8444S
- Volvo XC90 (2003–)2012Kun motor: B6324S5
- Volvo XC90 (2003–)2013–2014Alle motorer unntatt: B5254T9
Hva betyr feilkoden?
On cars with DSTC, the brake control module (BCM) supplies the stability sensor with voltage when the ignition is switched on. If the supply voltage to the AYC sensor falls outside the permitted range, even though the module has not energised it, the code is set.
Mulige årsaker
- Contact resistance or oxidation in connectors and joints
- Wires to the AYC sensor's supply shorted to ground or supply voltage
- Break in the wire to the AYC sensor's supply
- Internal fault in the AYC sensor
Hva du kan gjøre
- 1Read and note the code, clear it and road test the car. If the code is intermittent, poor contact is the likely cause
- 2Check the connectors at the brake control module and the AYC sensor for contact resistance and oxidation
- 3Check the supply wire to the sensor for a short to ground or supply voltage, and for breaks
- 4Read the supply voltage with diagnostic equipment and replace the sensor if the supply is in order
- 5The braking system is safety critical: do not work on the sensor or braking system yourself; leave this to a workshop
Symptomer du kan merke5
- General warning lamp on
- Anti-spin function does not work
- Stability function does not work
- Anti-skid function does not work
- Adaptive cruise control and collision warning do not work
Hva feilen kan påvirke1
- Traction control, stability control and dynamic stability control (AYC) are blocked
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.