Hva betyr feilkode BCM-C111154?

Diagnose og feilkodedefinisjon for BCM-C111154 (Volvo XC90 (2003–), Volvo XC90 (2003–), Volvo XC90 (2003–)). Bestill reparasjon hos OBD Tuning.

VOLVO

BCM-C111154 - AYC sensor. Programming error. Calibration missing

System

Bremsestyring (BCM)

Volvo-modeller feilkoden gjelder for

Gjelder følgende modeller:

1 modell

XC90 (2003–)

Vis modeller per årsmodell og motor (5)

Hva betyr feilkoden?

At start-up the brake control module (BCM) checked the stored calibration values for the stability sensors and found that they do not match. The code most often means the sensors have not been calibrated, for example after a software update. The stability systems stay switched off until calibration has been carried out. The code only applies to cars with DSTC.

Mulige årsaker

Sensors not calibrated
Code stored during a software download

Hva du kan gjøre

1If the code was stored during a software download, clearing it is usually enough
2Otherwise have a workshop calibrate the brake control module and the sensors; the car must stand level and nobody should press the brake pedal during the calibration
3Read the code status after a while without switching the ignition off; if the status has moved from permanent to intermittent, the fault is currently inactive
4If the code keeps a permanent status, have a workshop replace the AYC sensor
5The brake system is safety-critical, so have a workshop carry out the calibration and any replacement

Symptomer du kan merke4

General warning lamp on
Traction control does not work
Stability function does not work
Anti-skid function does not work

Hva feilen kan påvirke1

Traction control, stability control and dynamic stability control (AYC) are disabled

Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.