BCM-U042862 - Invalid Data Received From Steering Angle Sensor Module. Algorithm Based Failures. Signal compare failure
System
Bremsestyring (BCM)
Volvo-modeller feilkoden gjelder for
Feilkoden har ulik betydning avhengig av modell, årsmodell eller motor. Velg betydningen som gjelder din bil.
Gjelder følgende modeller:
13 modellerC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V50 (2004–2013), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Vis modeller per årsmodell og motor (14)
- Volvo C30 (2007–2013)2011–2013Kun motor: D4162T, D5204T, D5204T5
- Volvo C70 (2006–2013)2011Kun motor: D5204T, D5204T5
- Volvo C70 (2006–2013)2012–2013Alle motorer unntatt: B5254T7
- Volvo S40 (2004–2013)2011–2012Kun motor: D4162T, D5204T, D5204T5
- Volvo S60 (2011–)2011–2015
- Volvo S80 (2007–)2007–2015
- Volvo V40 (2013–)2013–2015
- Volvo V40 Cross Country (2013–)2013–2015
- Volvo V50 (2004–2013)2011–2012Kun motor: D4162T, D5204T, D5204T5
- Volvo V60 (2011–)2011–2015
- Volvo V60 Cross Country (2015–)2015
- Volvo V70 (2008–)2008–2015
- Volvo XC60 (2009–)2009–2015
- Volvo XC70 (2008–)2008–2015
Hva betyr feilkoden?
At each new ignition cycle the brake control module (BCM) compares the steering angle from the steering angle sensor with a calculated value. The code is set when the difference between the two values is too large, which most often happens when the steering angle sensor has not been initialised during a longer drive. It applies to cars with a stability system and can be set when stability has been regulated for too long.
Mulige årsaker
- The driver has driven for a long time with an uninitialised steering angle sensor after start-up
- The driver drove with an uninitialised steering angle sensor and then switched the ignition off
- Internal fault in the steering angle sensor control module (SAS)
Hva du kan gjøre
- 1If other codes are stored in the module, troubleshoot them first
- 2Check the front wheel alignment and have a workshop adjust it if needed
- 3Think back on whether the car has been driven for a long time without the steering wheel being turned after start-up
- 4The brake and stability systems are safety-critical, so have a workshop carry out any work on the steering angle sensor and the brake control module
Symptomer du kan merke5
- Traction and anti-skid warning lamp lit
- Stability function does not work
- Traction control does not work
- Anti-skid function does not work
- Adaptive cruise control does not work
Hva feilen kan påvirke3
- Stability control is disabled
- Traction control is disabled
- Dynamic stability control (AYC) is disabled
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.