VOLVO
CEM-8F11 - Light width control. Signal too high. Intermittent fault
System
Sentral elektronikk (CEM)
Volvo-modeller feilkoden gjelder for
Feilkoden har ulik betydning avhengig av modell, årsmodell eller motor. Velg betydningen som gjelder din bil.
Gjelder følgende modeller:
5 modellerS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Hva betyr feilkoden?
The fault is intermittent: the signal from the beam height control was too high on an earlier occasion, but it is no longer present. The central electronic module (CEM) compares the voltage at the beam height control with its own supply voltage and records the fault when the difference becomes too large, so the low beam setting can end up wrong.
Mulige årsaker
- Defective beam height control actuator
- Signal wire short-circuited to voltage
Hva du kan gjøre
- 1Clear the code and check whether it returns; an intermittent fault can be a temporary disturbance
- 2Look for chafing, pinching and breaks in the signal wire to the beam height control
- 3With the ignition off, gently move the wiring and connectors to see whether anything causes a loose contact
- 4Use a multimeter to check that the signal wire has no contact with voltage when the ignition is off
- 5If you have a diagnostic tool, run the actuator and check that the low beam moves smoothly up and down
- 6If the fault returns after these checks, have a workshop replace the actuator motor
Symptomer du kan merke1
- The beam height adjustment does not work
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.