Hopp til innhold
    OBD Tuning
    SEND TIL OSS
    SEND TIL OSS
    Hjem
    Feilkoder
    VOLVO
    CEM-B112A12
    VOLVO

    CEM-B112A12 - Relay B 15-feed. General Electrical Failures. Circuit short to battery

    System

    Sentral elektronikk (CEM)

    Volvo-modeller feilkoden gjelder for

    Gjelder følgende modeller:

    9 modeller

    S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)

    Vis modeller per årsmodell og motor (9)
    • Volvo S60 (2011–)2011–2015
    • Volvo S80 (2007–)2007–2015
    • Volvo V40 (2013–)2013–2015
    • Volvo V40 Cross Country (2013–)2013–2015
    • Volvo V60 (2011–)2011–2015
    • Volvo V60 Cross Country (2015–)2015
    • Volvo V70 (2008–)2008–2015
    • Volvo XC60 (2009–)2009–2015
    • Volvo XC70 (2008–)2008–2015

    Hva betyr feilkoden?

    The CEM controls a distribution relay for the 15 feed, which is switched on when the ignition is turned on. On cars built before mid-November 2009, the relay is in the rear fuse box in the luggage compartment. On later cars it sits in the fuse box in the cabin, next to the CEM. The code is stored when the output to the relay coil is short-circuited to supply voltage.

    Mulige årsaker

    • The cable is short-circuited to supply voltage

    Hva du kan gjøre

    1. 1Check that the relevant fuses are intact. Their locations are in the owner's manual or on the fuse box cover
    2. 2The relay is in the luggage compartment fuse box on cars built before mid-November 2009, and in the cabin on later cars
    3. 3Use a multimeter to check whether the relay wire has voltage when the ignition is off
    4. 4Look for chafing and pinch damage on the cable to the relay
    5. 5If you have a diagnostic tool: activate the all-wheel drive or the active chassis and check whether the function responds
    6. 6If the fault returns, have a workshop with diagnostic equipment check the relay and the wiring

    Symptomer du kan merke3

    • All-wheel drive does not work
    • Four-C function does not work
    • Active chassis does not work

    Hva feilen kan påvirke3

    • The function switches off in the driving cycle in which the fault is detected
    • Permanent shut-off follows after 100 driving cycles with the fault
    • Clearing the fault codes and starting a new driving cycle resets the output

    Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.

    OBD Tuning

    Sveriges ledende ekspertsenter for bilelektronikk. Vi tilbyr profesjonell ECU-tuning, reparasjon av styreenheter og diagnostikk med 12 måneders garanti.

    Tjenester

    • Motoroptimalisering
    • ECU Reparasjon
    • Modulkloning
    • Instrumentpanel
    • SRS / Airbag
    • Startsperre

    Database & Diagnostikk

    • ECU-database
    • DTC Feilkodekatalog
    • Diagnoseguider & Måleverdier
    • AI Feilkodeanalysator
    • Nyheter

    ECU-produsenter

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Selskap

    • Om oss
    • Kontakt
    • Verkstedpartnere
    • Fraktguide
    • Garanti
    • FAQ
    • Vilkår
    • Personvern
    • Nettstedskart

    • Motoroptimalisering
    • ECU Reparasjon
    • Modulkloning
    • Instrumentpanel
    • SRS / Airbag
    • Startsperre

    • ECU-database
    • DTC Feilkodekatalog
    • Diagnoseguider & Måleverdier
    • AI Feilkodeanalysator
    • Nyheter

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • Om oss
    • Kontakt
    • Verkstedpartnere
    • Fraktguide
    • Garanti
    • FAQ
    • Vilkår
    • Personvern
    • Nettstedskart

    Besøk oss

    Gjuterigatan 29, Karlstad

    Ring oss

    054-830 480

    E-post oss

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Alle rettigheter forbeholdt.