VOLVO
CEM-P080111 - Reverse Inhibit Control Circuit. General Electrical Failures. Circuit short to ground
System
Sentral elektronikk (CEM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
9 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Hva betyr feilkoden?
The CEM monitors the reverse gear inhibit, which stops reverse from being engaged while the car moves forward. The signal cable is shorted to earth, so the voltage is too low and the inhibit may stop working. The fault is most often noticed when the gear lever is stiff or will not go into reverse.
Mulige årsaker
- The signal wire to the reverse inhibit is shorted to earth
Hva du kan gjøre
- 1Check that the reverse inhibit fuses in the engine bay fuse box and in the CEM are intact
- 2Use a multimeter to check that the signal wire to the reverse inhibit is not shorted to earth
- 3Check the connectors on the signal wire for damage, corrosion and loose connections
- 4With a diagnostic tool, clear the fault codes, start a new driving cycle and read the fault code again. If it returns straight away, the fault is active
- 5If no short is found in the wiring, a workshop should check the relay and the CEM output
- 6The reverse inhibit stops reverse being engaged while driving. If it does not work, avoid trying to select reverse while the car moves, and have a workshop fix it
Symptomer du kan merke2
- The reverse gear inhibit does not work
- The gear lever is hard or impossible to move into reverse
Hva feilen kan påvirke2
- The inhibit is switched off during the driving cycle in which the fault is detected
- After 100 driving cycles with the fault present, the inhibit is switched off permanently
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.