VOLVO
CEM-U000112 - High Speed CAN Communication Bus. General Electrical Failures. Circuit short to battery
System
Sentral elektronikk (CEM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
7 modellerS60 (2011–), S80 (2007–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Hva betyr feilkoden?
One of the high speed CAN wires has contact with battery voltage, which disturbs communication between the control modules. The engine may then have trouble starting, and driving and the gauges are affected. The fault most often lies in the high speed network wiring.
Mulige årsaker
- Short circuit between one of the CAN wires and supply voltage
Hva du kan gjøre
- 1Note which driving faults occur, for example at start, acceleration or steady speed. This shows which parts of the harness may be damaged
- 2Check that the high speed harness is not chafed, pinched or damaged by moisture
- 3Check the high speed network connectors for loose connections and corrosion
- 4With a diagnostic tool, read the fault codes from all control modules and start with those for the CAN network
- 5Use a multimeter to check that the CAN wires have no contact with battery voltage when they should not
- 6An engine that will not start or stalls while driving is a safety problem. Have a workshop trace the fault promptly
Symptomer du kan merke5
- The engine does not start even though the starter turns
- Poor performance and lack of power
- The throttle response hesitates, surges or is jerky
- Cruise control cannot be engaged
- The speedometer and tachometer show wrong readings
Hva feilen kan påvirke1
- The module stays switched off until its power supply is cut
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.