VOLVO
CPM-B1D3292 - Multiple flame interruption during heating cycle. Component Failures. Performance or incorrect operation
System
Forbrenningsvarmer (CPM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
9 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Hva betyr feilkoden?
The flame goes out repeatedly during warm-up, in a way that is not permitted when the heater runs at half speed. The control module then switches the heater off. The fault may be caused by fuel problems such as a low level, a leak or air in the fuel, a blocked intake or exhaust system, or a dirty or damaged flame sensor.
Mulige årsaker
- Car parked on a steep slope
- Low fuel level
- Leak, air or a blocked fuel system
- Damaged fuel pump
- Blocked intake or exhaust system
- Sooty or damaged flame sensor
Hva du kan gjøre
- 1Park the vehicle on level ground and try starting the heater again. A steep slope can make the flame go out.
- 2Check the fuel level in the tank and top up if it is low.
- 3Use gloves and safety goggles, as fuel can spill. With the ignition off, check the fuel lines for leaks.
- 4Inspect the air inlet and the exhaust pipe for obstructions and clear them. Tighten or replace a leaking clamp.
- 5Look at the flame sensor. If it is sooty or damaged, a workshop can clean or replace it.
- 6If the fault remains after these checks, have a workshop check the fuel pump and the fuel supply.
Symptomer du kan merke3
- Poor heating in the cabin
- The parking or auxiliary heater does not work when it is activated
- The parking heater does not work
Hva feilen kan påvirke2
- The heater is switched off when the fault occurs
- The heater makes a new start attempt if it is activated again
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.