VOLVO
DCDC-P060C00 - Internal Control Module Main Processor Performance. General Failure Information. No sub type information
System
Ukjent system / Merkespesifikk
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
1 modellV60 (2011–)
Vis modeller per årsmodell og motor (2)
Hva betyr feilkoden?
The control module for the DC/DC converter, which converts power from the high voltage battery to the car's ordinary electrical system, has found an internal fault in its main processor. The fault is generic and gives no further detail on the fault type. The code is tested when the ignition is switched on and is only stored when the fault is actually present. Because the converter is part of the high voltage system, charging of the high voltage battery is affected.
Mulige årsaker
- Internal fault in the DC/DC converter control module
Hva du kan gjøre
- 1Switch the ignition off, wait a moment and switch it on again. Then check whether the warning has cleared
- 2Read and note the code, clear it and drive the car for a while to see whether it returns
- 3If the fault returns after a restart, have a workshop check the high voltage system and replace the control module if needed
- 4The high voltage system may only be handled by qualified personnel. Do not work on the converter or its wiring yourself
Symptomer du kan merke4
- Warning symbol and message in the display
- The high voltage battery does not charge, or charging is reduced while driving
- Drive modes PURE, SAVE and AWD disengage automatically or cannot be selected
- The combustion engine runs all the time or too often in HYBRID mode
Hva feilen kan påvirke2
- The high voltage battery is not charged
- Hybrid drive mode is forced
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.