VOLVO
DEM-P188E01 - Oil Pressure Pump Control Circuit. General Failure Information. General electrical failure
System
Firehjulsdrift (DEM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
8 modellerS60 (2011–), S80 (2007–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Hva betyr feilkoden?
The current in the control circuit to the oil pressure pump is outside the expected range, and the four-wheel drive control module (DEM) detects this while driving. The cause can be an electrical fault in the cable, such as a short to voltage or to ground, or an internal leak in the pump.
Mulige årsaker
- Damaged connector between the oil pressure pump and the control module
- Voltage supply cable shorted to voltage
- Voltage supply cable shorted to ground
- Open circuit or short to ground in the cable
- Internal leak in the oil pressure pump
- Damaged oil pressure pump
Hva du kan gjøre
- 1Read off the fault code, note it and clear it. Test drive the vehicle to see if the fault returns
- 2Check that the fuses are intact; their locations are in the owner's manual or on the fuse box cover
- 3Follow the wiring between the control module and the pump for chafing, pinched areas and loose clips, and check the connector at both ends
- 4Use a multimeter to confirm the cable has no contact with ground (body). With the ignition on, also check whether the cable has voltage when it should not
- 5If you have a diagnostic tool, read the pump current in live data with the engine running and check whether the value is steady or jumps
- 6Have a workshop check the pump and replace it if it is damaged, and calibrate the control module after the change
Symptomer du kan merke2
- Four-wheel drive does not work
- Warning symbol and text message in the display
Hva feilen kan påvirke1
- Four-wheel drive is disengaged for as long as the fault is present
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.