VOLVO
ECM-1114 - Secondary speed. Signal too high
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
2 modellerS40 (1996–2004), V40 (1996–2004)
Vis modeller per årsmodell og motor (2)
Hva betyr feilkoden?
The engine control module has registered that the speed from the needle lift sensor has been too high, or that the needle lift sensor reading disagrees with the speed from the impulse sensor. The fault concerns an abnormal signal, so the engine may have been running at a speed the sensor should not report. The code is set when the deviation occurs.
Mulige årsaker
- Needle lift sensor signal too high, showing an engine speed the engine should not have
- Defective needle lift sensor
- Fault in the fuel supply
Hva du kan gjøre
- 1Read and note the code, clear it and road test to see whether it returns
- 2Check that the fuel is clean and that the fuel supply has no leaks or air in the system
- 3Inspect the needle lift sensor connector and cable for damage and oxidation
- 4If the fault remains after these checks, have a workshop with diagnostic equipment examine the needle lift sensor and the fuel supply
Symptomer du kan merke1
- The malfunction indicator lamp comes on
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.