VOLVO
ECM-140D - Outside temperature sensor. Signal too low
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
8 modellerC70 (2006–2013), S40 (2004–2013), S60 (2001–2009), S80 (1999–2006), V50 (2004–2013), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Vis modeller per årsmodell og motor (17)
- Volvo C70 (2006–2013)2006Kun motor: B5254T3
- Volvo S40 (2004–2013)2005–2006Kun motor: B5254T3
- Volvo S60 (2001–2009)2005–2006Kun motor: B5204T5, B5244T4, B5244T5, B5254T2, B5254T4
- Volvo S60 (2001–2009)2007Kun motor: B5204T5, B5244T5, B5254T2, B5254T4
- Volvo S60 (2001–2009)2008–2009Kun motor: B5204T5, B5244T5, B5254T2
- Volvo S80 (1999–2006)2005–2006Kun motor: B5204T5, B5244T4, B5254T2, B6294S2, B6294T
- Volvo V50 (2004–2013)2005–2006Kun motor: B5254T3
- Volvo V70 (2000–2008)2005Kun motor: B5204T5, B5244T4, B5244T5, B5254T2, B5254T4
- Volvo V70 (2000–2008)2006–2007Kun motor: B5204T5, B5244T5, B5254T2, B5254T4
- Volvo V70 (2000–2008)2008Kun motor: B5254T2
- Volvo V70 XC / XC70 (2001–2007)2005Alle motorer unntatt: D5244T
- Volvo V70 XC / XC70 (2001–2007)2006Kun motor: B5244T4, B5254T2
- Volvo V70 XC / XC70 (2001–2007)2007Kun motor: B5254T2
- Volvo XC90 (2003–)2005–2006Kun motor: B5254T2, B6294T
- Volvo XC90 (2003–)2007–2012Kun motor: B5254T2
- Volvo XC90 (2003–)2013–2014Kun motor: B5254T9
- Volvo XC90 (2003–)2015
Hva betyr feilkoden?
The fault is set when the outside air temperature sensor is shorted to voltage, and also when the central electronics module (CEM) judges the signal to be too low. The signal reaches the engine control module (ECM) over the CAN bus.
Mulige årsaker
- Contact resistance in the connections
- Signal wire shorted to voltage
- Open circuit in the signal wire
- Damaged outside air temperature sensor
Hva du kan gjøre
- 1First read the fault codes in the central electronics module (CEM) and fix them
- 2Check the wiring and connectors to the outside air temperature sensor for contact resistance and oxidation
- 3If you have a diagnostic tool: read the outside temperature in live data with the ignition on; if it becomes reasonable once the connector is cleaned, poor contact was the likely cause
- 4The sensor may have been damaged by the signal wire being shorted to voltage; check the wiring before replacing the sensor
- 5If the wiring is fault-free but the fault remains: have a workshop measure the sensor's resistance and replace it if needed
Symptomer du kan merke3
- Engine warning lamp comes on
- Starting problems, the engine cranks slowly
- The outside temperature gauge shows wrong values or does not work
Hva feilen kan påvirke1
- The engine uses the value from the intake air temperature sensor
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.