VOLVO
ECM-222B - Rear heated oxygen sensor (HO2S), bank 1. Signal missing
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
9 modellerC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2001–2009), S80 (1999–2006), V50 (2004–2013), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Vis modeller per årsmodell og motor (23)
- Volvo C30 (2007–2013)2007Kun motor: B5254T3
- Volvo C30 (2007–2013)2008–2013Kun motor: B5254T7
- Volvo C70 (2006–2013)2006–2007Kun motor: B5254T3
- Volvo C70 (2006–2013)2008–2013Kun motor: B5254T7
- Volvo S40 (2004–2013)2005–2007Kun motor: B5254T3
- Volvo S40 (2004–2013)2008Kun motor: B5254T3, B5254T7
- Volvo S40 (2004–2013)2009–2012Kun motor: B5254T7
- Volvo S60 (2001–2009)2005–2006Kun motor: B5204T5, B5244T4, B5244T5, B5254T2, B5254T4
- Volvo S60 (2001–2009)2007Kun motor: B5204T5, B5244T5, B5254T2, B5254T4
- Volvo S60 (2001–2009)2008–2009Kun motor: B5204T5, B5244T5, B5254T2
- Volvo S80 (1999–2006)2005–2006Kun motor: B5204T5, B5244T4, B5254T2, B6294S2, B6294T
- Volvo V50 (2004–2013)2005–2007Kun motor: B5254T3
- Volvo V50 (2004–2013)2008–2012Kun motor: B5254T7
- Volvo V70 (2000–2008)2005Kun motor: B5204T5, B5244T4, B5244T5, B5254T2, B5254T4
- Volvo V70 (2000–2008)2006–2007Kun motor: B5204T5, B5244T5, B5254T2, B5254T4
- Volvo V70 (2000–2008)2008Kun motor: B5254T2
- Volvo V70 XC / XC70 (2001–2007)2005Alle motorer unntatt: D5244T
- Volvo V70 XC / XC70 (2001–2007)2006Kun motor: B5244T4, B5254T2
- Volvo V70 XC / XC70 (2001–2007)2007Kun motor: B5254T2
- Volvo XC90 (2003–)2005–2006Kun motor: B5254T2, B6294T
- Volvo XC90 (2003–)2007–2012Kun motor: B5254T2
- Volvo XC90 (2003–)2013–2014Kun motor: B5254T9
- Volvo XC90 (2003–)2015
Hva betyr feilkoden?
The engine control module (ECM) monitors the signal from the rear oxygen sensor on bank 1, the sensor after the catalytic converter. The code is set when the signal is missing or outside its permitted range, or when the sensor heater disturbs the signal. Rear oxygen sensor control is then switched off, and so is the check of the catalytic converter.
Mulige årsaker
- Poor contact or oxidation in the sensor connector
- Open circuit in the signal or ground wire between the sensor and the engine control module
- Signal wire short-circuited to ground
- Damaged rear oxygen sensor
Hva du kan gjøre
- 1Read the code, note it, clear it and road test to see whether it returns
- 2Check that the connector at the rear oxygen sensor is secure and free from corrosion and oxidation
- 3Follow the wire from the sensor and look for chafing, breaks or loose clips, especially where it runs under the car
- 4If you have a diagnostic tool: watch the oxygen sensor signal in live data while the engine runs and see whether the value changes
- 5Use a multimeter to check that the signal wire is not shorted to ground and has continuity all the way from the sensor
- 6If the fault remains after these checks, have a workshop decide whether the sensor needs replacing
Symptomer du kan merke1
- Malfunction indicator lamp (MIL) lit
Hva feilen kan påvirke2
- Rear oxygen sensor control after the catalytic converter is switched off
- The catalytic converter cannot be checked
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.