VOLVO
ECM-223B - Rear heated oxygen sensor (HO2S), bank 1. Signal missing
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
9 modellerC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2001–2009), S80 (1999–2006), V50 (2004–2013), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Vis modeller per årsmodell og motor (23)
- Volvo C30 (2007–2013)2007Kun motor: B5254T3
- Volvo C30 (2007–2013)2008–2013Kun motor: B5254T7
- Volvo C70 (2006–2013)2006–2007Kun motor: B5254T3
- Volvo C70 (2006–2013)2008–2013Kun motor: B5254T7
- Volvo S40 (2004–2013)2005–2007Kun motor: B5254T3
- Volvo S40 (2004–2013)2008Kun motor: B5254T3, B5254T7
- Volvo S40 (2004–2013)2009–2012Kun motor: B5254T7
- Volvo S60 (2001–2009)2005–2006Kun motor: B5204T5, B5244T4, B5244T5, B5254T2, B5254T4
- Volvo S60 (2001–2009)2007Kun motor: B5204T5, B5244T5, B5254T2, B5254T4
- Volvo S60 (2001–2009)2008–2009Kun motor: B5204T5, B5244T5, B5254T2
- Volvo S80 (1999–2006)2005–2006Kun motor: B5204T5, B5244T4, B5254T2, B6294S2, B6294T
- Volvo V50 (2004–2013)2005–2007Kun motor: B5254T3
- Volvo V50 (2004–2013)2008–2012Kun motor: B5254T7
- Volvo V70 (2000–2008)2005Kun motor: B5204T5, B5244T4, B5244T5, B5254T2, B5254T4
- Volvo V70 (2000–2008)2006–2007Kun motor: B5204T5, B5244T5, B5254T2, B5254T4
- Volvo V70 (2000–2008)2008Kun motor: B5254T2
- Volvo V70 XC / XC70 (2001–2007)2005Alle motorer unntatt: D5244T
- Volvo V70 XC / XC70 (2001–2007)2006Kun motor: B5244T4, B5254T2
- Volvo V70 XC / XC70 (2001–2007)2007Kun motor: B5254T2
- Volvo XC90 (2003–)2005–2006Kun motor: B5254T2, B6294T
- Volvo XC90 (2003–)2007–2012Kun motor: B5254T2
- Volvo XC90 (2003–)2013–2014Kun motor: B5254T9
- Volvo XC90 (2003–)2015
Hva betyr feilkoden?
The engine control module (ECM) controls the heating of the rear oxygen sensor on bank 1 by pulsing the current to the sensor heating element. The code is set when the signal from the sensor is too low while heating is switched off. With a diagnostic tool you can see whether the fault is permanent or intermittent. It is often caused by poor contact or by the power supply from the system relay being interrupted.
Mulige årsaker
- Contact resistance and oxidation in the sensor terminals
- Open circuit in the power supply to the sensor from the system relay
- Damaged rear oxygen sensor
Hva du kan gjøre
- 1If you have a diagnostic tool: once the diagnostic is complete, read the fault status
- 2Fault found means the fault is permanent; No fault found means it is intermittent and not active now
- 3Check that the connector to the rear oxygen sensor is secure and not oxidised
- 4Use a multimeter to confirm the supply wire has continuity all the way from the system relay to the sensor
- 5Do not use rust solvent spray or grease in the sensor connector
- 6If the fault remains after these checks, have a workshop decide whether the sensor should be replaced
Symptomer du kan merke1
- Malfunction indicator lamp (MIL) lit
Hva feilen kan påvirke1
- Fuel trim is switched off
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.