VOLVO
ECM-244C - Front heated oxygen sensor (HO2S), bank 1, heating. Signal too high
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
9 modellerC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2001–2009), S80 (1999–2006), V50 (2004–2013), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Vis modeller per årsmodell og motor (23)
- Volvo C30 (2007–2013)2007Kun motor: B5254T3
- Volvo C30 (2007–2013)2008–2013Kun motor: B5254T7
- Volvo C70 (2006–2013)2006–2007Kun motor: B5254T3
- Volvo C70 (2006–2013)2008–2013Kun motor: B5254T7
- Volvo S40 (2004–2013)2005–2007Kun motor: B5254T3
- Volvo S40 (2004–2013)2008Kun motor: B5254T3, B5254T7
- Volvo S40 (2004–2013)2009–2012Kun motor: B5254T7
- Volvo S60 (2001–2009)2005–2006Kun motor: B5204T5, B5244T4, B5244T5, B5254T2, B5254T4
- Volvo S60 (2001–2009)2007Kun motor: B5204T5, B5244T5, B5254T2, B5254T4
- Volvo S60 (2001–2009)2008–2009Kun motor: B5204T5, B5244T5, B5254T2
- Volvo S80 (1999–2006)2005–2006Kun motor: B5204T5, B5244T4, B5254T2, B6294S2, B6294T
- Volvo V50 (2004–2013)2005–2007Kun motor: B5254T3
- Volvo V50 (2004–2013)2008–2012Kun motor: B5254T7
- Volvo V70 (2000–2008)2005Kun motor: B5204T5, B5244T4, B5244T5, B5254T2, B5254T4
- Volvo V70 (2000–2008)2006–2007Kun motor: B5204T5, B5244T5, B5254T2, B5254T4
- Volvo V70 (2000–2008)2008Kun motor: B5254T2
- Volvo V70 XC / XC70 (2001–2007)2005Alle motorer unntatt: D5244T
- Volvo V70 XC / XC70 (2001–2007)2006Kun motor: B5244T4, B5254T2
- Volvo V70 XC / XC70 (2001–2007)2007Kun motor: B5254T2
- Volvo XC90 (2003–)2005–2006Kun motor: B5254T2, B6294T
- Volvo XC90 (2003–)2007–2012Kun motor: B5254T2
- Volvo XC90 (2003–)2013–2014Kun motor: B5254T9
- Volvo XC90 (2003–)2015
Hva betyr feilkoden?
The fault applies to the heating of the front oxygen sensor on bank 1. The engine control module (ECM) pulses the current to the sensor heating element and checks the signal. The code is stored when the signal reads over a set threshold with the heating active.
Mulige årsaker
- Signal cable short-circuited to supply voltage
- Damaged front heated oxygen sensor
Hva du kan gjøre
- 1Read and note the code, clear it and road test to see whether it comes back
- 2Check the oxygen sensor connector for oxidation and loose connections. Do not use rust solvent spray or grease in it
- 3If possible, take readings from the cable side of the connector so you do not damage it or create a loose contact later
- 4Use a multimeter to check that the signal cable is not short-circuited to supply voltage, meaning plus on the car
- 5If the cables are intact but the fault remains, have a workshop try a new oxygen sensor
Symptomer du kan merke1
- The malfunction indicator lamp (MIL) is lit
Hva feilen kan påvirke2
- Oxygen sensor control is switched off
- Fuel trim control based on the oxygen sensor is switched off
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.