VOLVO
ECM-257C - Front heated oxygen sensor (HO2S), bank 2. Signal too high
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
2 modellerS80 (1999–2006), XC90 (2003–)
Vis modeller per årsmodell og motor (2)
Hva betyr feilkoden?
The code is set when the engine control module (ECM) sees that the pump current to the oxygen sensor on bank 2 has stopped. The sensor is then given a default value as its signal, even though the fault is shown as a signal that is too high.
Mulige årsaker
- Oxidation or contact resistance in the connections
- The pump current wire is broken
- The oxygen sensor on bank 2 is damaged
Hva du kan gjøre
- 1Clear the code, road test the car and check whether it comes back
- 2Look at the connector at the lambda sensor: it should be seated firmly and free from oxide. Keep rust solvent spray and grease off the connector
- 3Use a multimeter to check that the pump current wire to the sensor has continuity throughout
- 4Look for breaks and chafing on the wires, especially where they lie close to heat
- 5If the wires are intact but the fault remains, have a workshop check the lambda sensor
Symptomer du kan merke1
- Malfunction indicator lamp (MIL) on
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.