VOLVO
ECM-291D - Fuel pump control module. Signal too low
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
9 modellerC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2001–2009), S80 (1999–2006), V50 (2004–2013), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Vis modeller per årsmodell og motor (23)
- Volvo C30 (2007–2013)2007Kun motor: B5254T3
- Volvo C30 (2007–2013)2008–2013Kun motor: B5254T7
- Volvo C70 (2006–2013)2006–2007Kun motor: B5254T3
- Volvo C70 (2006–2013)2008–2013Kun motor: B5254T7
- Volvo S40 (2004–2013)2005–2007Kun motor: B5254T3
- Volvo S40 (2004–2013)2008Kun motor: B5254T3, B5254T7
- Volvo S40 (2004–2013)2009–2012Kun motor: B5254T7
- Volvo S60 (2001–2009)2005–2006Kun motor: B5204T5, B5244T4, B5244T5, B5254T2, B5254T4
- Volvo S60 (2001–2009)2007Kun motor: B5204T5, B5244T5, B5254T2, B5254T4
- Volvo S60 (2001–2009)2008–2009Kun motor: B5204T5, B5244T5, B5254T2
- Volvo S80 (1999–2006)2005–2006Kun motor: B5204T5, B5244T4, B5254T2, B6294S2, B6294T
- Volvo V50 (2004–2013)2005–2007Kun motor: B5254T3
- Volvo V50 (2004–2013)2008–2012Kun motor: B5254T7
- Volvo V70 (2000–2008)2005Kun motor: B5204T5, B5244T4, B5244T5, B5254T2, B5254T4
- Volvo V70 (2000–2008)2006–2007Kun motor: B5204T5, B5244T5, B5254T2, B5254T4
- Volvo V70 (2000–2008)2008Kun motor: B5254T2
- Volvo V70 XC / XC70 (2001–2007)2005Alle motorer unntatt: D5244T
- Volvo V70 XC / XC70 (2001–2007)2006Kun motor: B5244T4, B5254T2
- Volvo V70 XC / XC70 (2001–2007)2007Kun motor: B5254T2
- Volvo XC90 (2003–)2005–2006Kun motor: B5254T2, B6294T
- Volvo XC90 (2003–)2007–2012Kun motor: B5254T2
- Volvo XC90 (2003–)2013–2014Kun motor: B5254T9
- Volvo XC90 (2003–)2015
Hva betyr feilkoden?
The engine control module controls the fuel pressure by sending a PWM signal to the fuel pump control module. The code is stored when that signal is too low, which can come from a signal wire shorted to ground, a damaged pump control module, or a damaged ground or power supply to the pump control module and pump.
Mulige årsaker
- Signal wire shorted to ground
- Damaged fuel pump control module
- Damaged power supply cable to the pump control module
- Damaged earth connection to the pump control module and pump
- Poor contact, oxide or high resistance at the connectors
- Cable between the pump control module and the fuel pump shorted to voltage or ground
Hva du kan gjøre
- 1If you have a diagnostic tool: read the fuel pump load in live data with the engine warm and idling. A value that is wrong or missing points to a lasting fault
- 2Check that the earth connection to the pump control module and pump is secure and clean
- 3Check the connector at the pump control module for contact resistance and oxide
- 4With the car switched off, use a multimeter to check that the signal wire is not shorted to ground
- 5Check the voltage supply to the pump control module, including the relay and fuse
- 6If no fault is found, have a workshop try a new fuel pump control module
Symptomer du kan merke5
- Starter turns, but the engine does not fire
- Engine stops
- Engine lacks power, especially when moving off
- Engine hesitates or surges when holding a steady speed
- Check engine lamp comes on or behaves abnormally
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.