VOLVO
ECM-3310 - Ignition coil cylinder 2. Faulty signal
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Feilkoden har ulik betydning avhengig av modell, årsmodell eller motor. Velg betydningen som gjelder din bil.
Gjelder følgende modeller:
7 modellerC70 Cabriolet (1998–2005), C70 Coupé (1998–2002), S60 (2001–2009), S70 (1997–2000), S80 (1999–2006), V70 (1997–2000), V70 (2000–2008)
Vis modeller per årsmodell og motor (22)
- Volvo C70 Cabriolet (1998–2005)2000Kun motor: B5244S
- Volvo C70 Coupé (1998–2002)1999Kun motor: B5254S DENSO
- Volvo C70 Coupé (1998–2002)2000Kun motor: B5244S
- Volvo S60 (2001–2009)2001Kun motor: B5244S, B5244S2
- Volvo S60 (2001–2009)2002Kun motor: B5244S, B5244S2, B5244SG, B5244SG2
- Volvo S60 (2001–2009)2003–2004Kun motor: B5244S, B5244S2, B5244S6, B5244SG, B5244SG2
- Volvo S60 (2001–2009)2005Kun motor: B5244SG, B5244SG2
- Volvo S60 (2001–2009)2006–2008Kun motor: B5244SG
- Volvo S70 (1997–2000)1999Kun motor: B5254S DENSO
- Volvo S70 (1997–2000)2000Kun motor: B5244S, B5244S2, B5244SG, B5244SG2
- Volvo S80 (1999–2006)1999–2000Kun motor: B5244S, B5244S2
- Volvo S80 (1999–2006)2001Kun motor: B5244S, B5244S2, B5244SG
- Volvo S80 (1999–2006)2002–2004Kun motor: B5244S, B5244S2, B5244SG, B5244SG2
- Volvo S80 (1999–2006)2005Kun motor: B5244SG, B5244SG2
- Volvo S80 (1999–2006)2006Kun motor: B5244SG
- Volvo V70 (1997–2000)1999Kun motor: B5254S DENSO
- Volvo V70 (1997–2000)2000Kun motor: B5244S, B5244S2, B5244SG, B5244SG2
- Volvo V70 (2000–2008)2001Kun motor: B5244S, B5244S2, B5244SG
- Volvo V70 (2000–2008)2002Kun motor: B5244S, B5244S2, B5244SG, B5244SG2
- Volvo V70 (2000–2008)2003–2004Kun motor: B5244S, B5244S2, B5244S6, B5244SG, B5244SG2
- Volvo V70 (2000–2008)2005Kun motor: B5244SG, B5244SG2
- Volvo V70 (2000–2008)2006–2008Kun motor: B5244SG
Hva betyr feilkoden?
The control module monitors the signal wire to the ignition coil for cylinder two, and the code shows that the fault concerns that coil. If a fault is registered on the wire, the code is stored, and the engine may misfire. Lambda control is disabled while the fault is present.
Mulige årsaker
- Signal wire short-circuited to supply voltage
- Signal wire short-circuited to ground
- Open circuit in the signal wire
- Loose connection in the connector
- Defective ignition coil
Hva du kan gjøre
- 1Run the engine at idle and check that it runs smoothly
- 2Look over the ignition coil plug for oxidation and a loose fit
- 3Use a multimeter to check that the signal wire to the coil has no contact with supply voltage
- 4Use a multimeter to check that the signal wire is not broken or shorted to ground
- 5If the fault remains after these checks, have a workshop replace the ignition coil
Symptomer du kan merke1
- The engine misfires
Hva feilen kan påvirke1
- Lambda control is disabled
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.