VOLVO
ECM-911C - Clutch pedal sensor. Signal too high
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
4 modellerC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Vis modeller per årsmodell og motor (9)
- Volvo C30 (2007–2013)2007Kun motor: B5254T3
- Volvo C30 (2007–2013)2008–2013Kun motor: B5254T7
- Volvo C70 (2006–2013)2006–2007Kun motor: B5254T3
- Volvo C70 (2006–2013)2008–2013Kun motor: B5254T7
- Volvo S40 (2004–2013)2005–2007Kun motor: B5254T3
- Volvo S40 (2004–2013)2008Kun motor: B5254T3, B5254T7
- Volvo S40 (2004–2013)2009–2012Kun motor: B5254T7
- Volvo V50 (2004–2013)2005–2007Kun motor: B5254T3
- Volvo V50 (2004–2013)2008–2012Kun motor: B5254T7
Hva betyr feilkoden?
The engine control module (ECM) has been sent an error report by the central electronic module (CEM) via CAN. It concerns a clutch pedal sensor that gives too high a signal, or a communication fault on the CAN network. There is no separate troubleshooting for this code, and it cannot be erased until the fault in the CEM is remedied.
Mulige årsaker
- Too high a signal from the clutch pedal sensor, reported by the CEM
- Fault in the communication on the CAN network
Hva du kan gjøre
- 1First remedy the fault codes in the central electronic module (CEM), as this code is set in the CEM first and then in the engine control module
- 2Erase the CEM fault codes once the cause is remedied, and then erase this code
- 3Check the connector at the clutch pedal sensor for loose contacts, oxidation and damage to the wiring
- 4If you have a diagnostic tool: read the clutch pedal position in live data and check that the value follows the pedal movement without jumps, from fully released to fully pressed
Symptomer du kan merke1
- The cruise control cannot be used at all
Hva feilen kan påvirke1
- The cruise control is switched off
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.