VOLVO
ECM-9430 - Accelerator pedal (AP) position sensor, analog signal. Faulty signal
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
4 modellerC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Vis modeller per årsmodell og motor (9)
- Volvo C30 (2007–2013)2007Kun motor: B5254T3
- Volvo C30 (2007–2013)2008–2013Kun motor: B5254T7
- Volvo C70 (2006–2013)2006–2007Kun motor: B5254T3
- Volvo C70 (2006–2013)2008–2013Kun motor: B5254T7
- Volvo S40 (2004–2013)2005–2007Kun motor: B5254T3
- Volvo S40 (2004–2013)2008Kun motor: B5254T3, B5254T7
- Volvo S40 (2004–2013)2009–2012Kun motor: B5254T7
- Volvo V50 (2004–2013)2005–2007Kun motor: B5254T3
- Volvo V50 (2004–2013)2008–2012Kun motor: B5254T7
Hva betyr feilkoden?
The ECM receives a fault message over CAN from the central electronic module (CEM). The message concerns either the analog accelerator pedal sensor signal or the CAN communication. The code is stored in the ECM, and fault tracing starts in the CEM.
Mulige årsaker
- Fault in the central electronic module (CEM), where fault tracing starts
Hva du kan gjøre
- 1Read the fault codes in the CEM first and deal with them. This code cannot be cleared until the CEM code has gone
- 2If you have a diagnostic tool: read the accelerator pedal value in live data with the engine running, while the pedal is pressed slowly and released
- 3If the code comes back once the CEM fault is remedied, have a workshop with diagnostic equipment fault-trace further
- 4The accelerator pedal can stop working when the brake is pressed. Do not drive with a fault in throttle response, and have a workshop check it at once
Symptomer du kan merke2
- Poor accelerator pedal response
- Cruise control does not function at all
Hva feilen kan påvirke1
- The accelerator pedal does not work when the brake pedal is pressed
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.