VOLVO
ECM-A6A0 - Ignition switch. Faulty signal
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
3 modellerC30 (2007–2013), S40 (2004–2013), V50 (2004–2013)
Vis modeller per årsmodell og motor (3)
Hva betyr feilkoden?
The engine control module receives the ignition key position from the central electronic module (CEM) over CAN. If that signal is missing or faulty, the code is set and the engine may not start. The fault may lie in the CEM, its power supply or the CAN wiring.
Mulige årsaker
- The ignition switch signal is missing or faulty
- There is no power supply to the central electronic module (CEM)
- Open circuit in the CAN wiring to the CEM
- CAN-related fault codes in the CEM
- An internal fault in a module on the same section of the CAN network
- The CEM is not intended for this car, for example if a used module with different software or hardware has been fitted
Hva du kan gjøre
- 1Read the fault codes in the central electronic module (CEM) first, since the fault is set there before it shows in the engine control module
- 2The code cannot be cleared until the code in the CEM has been remedied and erased
- 3Check the fuse and the connectors to the CEM if the supply may be broken; a multimeter can confirm that voltage is present
- 4Check the CAN wires between the engine control module and the CEM for open circuits and chafing
Symptomer du kan merke1
- The engine does not start
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.