VOLVO
ECM-P001821 - Crankshaft Position - Camshaft Position Correlation - Bank 2 Sensor A. General Signal Failures. Signal too low
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
1 modellS80 (2007–)
Vis modeller per årsmodell og motor (1)
Hva betyr feilkoden?
The engine control module compares the intake camshaft position with the crankshaft position and adjusts the adaptation when they do not agree. The code indicates a signal that is too low in bank 2, sensor A, and is set when the adaptation changes too much.
Mulige årsaker
- Incorrectly set camshafts
- Damaged VVT unit
Hva du kan gjøre
- 1Read the code and note whether it is active right now or only stored
- 2If you have a diagnostic tool: read the intake camshaft adaptation in live data with the engine running and note the value
- 3Check the connector at the camshaft sensor for loose or oxidised parts
- 4Check that the engine oil level is correct and that the oil is clean and of the right quality
- 5Have a workshop check the camshaft basic setting
- 6If the fault returns: have a workshop clean the control valve, or try a new one, and check the VVT unit
Symptomer du kan merke5
- The car lacks power when pulling away from standstill
- Engine is hard to start
- Uneven idle
- Engine hesitates or runs jerkily on acceleration
- Check engine lamp lit or behaving abnormally
Hva feilen kan påvirke1
- The control module uses a fixed value for the camshaft adaptation
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.