VOLVO
ECM-P003711 - HO2S Heater Control Circuit Low (Bank 1, Sensor 2). General Electrical Failures. Circuit short to ground
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
7 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–)
Vis modeller per årsmodell og motor (20)
- Volvo S60 (2011–)2011Kun motor: B4164T, B4164T3, B4204T6, B4204T7
- Volvo S60 (2011–)2012–2014Kun motor: B4164T, B4164T2, B4164T3, B4204T7
- Volvo S60 (2011–)2015Kun motor: B4164T, B4164T2, B4164T3
- Volvo S80 (2007–)2010Kun motor: B4204T6
- Volvo S80 (2007–)2011Kun motor: B4164T, B4204T6, B4204T7
- Volvo S80 (2007–)2012–2014Kun motor: B4164T, B4164T2, B4204T6, B4204T7
- Volvo S80 (2007–)2015Kun motor: B4164T
- Volvo V40 (2013–)2013Kun motor: B4164T, B4164T3
- Volvo V40 (2013–)2014–2015Kun motor: B4164T, B4164T3, B4164T4
- Volvo V40 Cross Country (2013–)2013–2015Kun motor: B4164T
- Volvo V60 (2011–)2011Kun motor: B4164T, B4164T3, B4204T6, B4204T7
- Volvo V60 (2011–)2012–2014Kun motor: B4164T, B4164T2, B4164T3, B4204T7
- Volvo V60 (2011–)2015Kun motor: B4164T, B4164T2, B4164T3
- Volvo V70 (2008–)2010Kun motor: B4204T6
- Volvo V70 (2008–)2011Kun motor: B4164T, B4204T6, B4204T7
- Volvo V70 (2008–)2012–2014Kun motor: B4164T, B4164T2, B4204T7
- Volvo V70 (2008–)2015Kun motor: B4164T, B4164T2
- Volvo XC60 (2009–)2010Kun motor: B4204T6
- Volvo XC60 (2009–)2011–2012Kun motor: B4204T6, B4204T7
- Volvo XC60 (2009–)2013–2015Kun motor: B4204T7
Hva betyr feilkoden?
The engine control module regulates the heating of the rear lambda sensor on bank 1, sensor 2, and sets the code when the signal falls below a set level while the heating is switched off. The fault is an electrical short to ground in the heater circuit, and lambda control is switched off.
Mulige årsaker
- Signal wire shorted to ground
- Faulty rear lambda sensor
Hva du kan gjøre
- 1Read the code, clear it and road test the car to see whether it returns
- 2Use a multimeter to check that the wire to the rear lambda sensor is not shorted to ground
- 3Check the connector at the lambda sensor, and do not use rust-release spray or grease in the connector
- 4Have a workshop check the resistance of the lambda sensor, and replace it if it is damaged
Symptomer du kan merke1
- Check engine lamp lit or behaving abnormally
Hva feilen kan påvirke1
- Lambda control is switched off
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.