VOLVO
ECM-P003E00 - Intake (A) Camshaft Profile Control Performance or Stuck Off (Bank 2). General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
5 modellerS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Vis modeller per årsmodell og motor (10)
- Volvo S80 (2007–)2007–2010Kun motor: B6324S
- Volvo S80 (2007–)2011–2015Kun motor: B6324S5
- Volvo V70 (2008–)2008–2010Kun motor: B6324S
- Volvo V70 (2008–)2011–2014Kun motor: B6324S5
- Volvo XC60 (2009–)2010Kun motor: B6324S
- Volvo XC60 (2009–)2011–2015Kun motor: B6324S5
- Volvo XC70 (2008–)2008–2010Kun motor: B6324S
- Volvo XC70 (2008–)2011–2015Kun motor: B6324S5
- Volvo XC90 (2003–)2007–2010Kun motor: B6324S
- Volvo XC90 (2003–)2011–2014Kun motor: B6324S5
Hva betyr feilkoden?
The intake cam profile control (A) is not working as it should on bank 2, which covers cylinders 3, 5 and 6. Intake manifold pressure is higher than expected for bank 2 compared with bank 1.
Mulige årsaker
- Dirty or damaged cam profile solenoid
- Blocked oil passages for the variable cam profile
Hva du kan gjøre
- 1Read the fault code with a diagnostic tool and see whether it is active or only stored
- 2If you have a diagnostic tool, activate the bank 2 solenoid and check that it responds
- 3Check the connector and wiring to the bank 2 solenoid for looseness, corrosion and damage
- 4Impurities or cast debris in the oil can make the solenoid stick. Cleaning is usually enough, but a workshop should do it because the solenoid is removed
- 5Replace the solenoid if the fault remains after two cleanings
Symptomer du kan merke4
- Malfunction indicator lamp (MIL) lights up
- Uneven idle
- Engine is hard to start
- Poor performance
Hva feilen kan påvirke1
- Both banks of the variable cam profile end up in low lift
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.