VOLVO
ECM-P013A22 - O2 Sensor Slow Response - Rich to Lean (Bank 1 and Sensor 2). General Signal Failures. Signal too high
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
7 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–)
Vis modeller per årsmodell og motor (20)
- Volvo S60 (2011–)2011Kun motor: B4164T, B4164T3, B4204T6, B4204T7
- Volvo S60 (2011–)2012–2014Kun motor: B4164T, B4164T2, B4164T3, B4204T7
- Volvo S60 (2011–)2015Kun motor: B4164T, B4164T2, B4164T3
- Volvo S80 (2007–)2010Kun motor: B4204T6
- Volvo S80 (2007–)2011Kun motor: B4164T, B4204T6, B4204T7
- Volvo S80 (2007–)2012–2014Kun motor: B4164T, B4164T2, B4204T6, B4204T7
- Volvo S80 (2007–)2015Kun motor: B4164T
- Volvo V40 (2013–)2013Kun motor: B4164T, B4164T3
- Volvo V40 (2013–)2014–2015Kun motor: B4164T, B4164T3, B4164T4
- Volvo V40 Cross Country (2013–)2013–2015Kun motor: B4164T
- Volvo V60 (2011–)2011Kun motor: B4164T, B4164T3, B4204T6, B4204T7
- Volvo V60 (2011–)2012–2014Kun motor: B4164T, B4164T2, B4164T3, B4204T7
- Volvo V60 (2011–)2015Kun motor: B4164T, B4164T2, B4164T3
- Volvo V70 (2008–)2010Kun motor: B4204T6
- Volvo V70 (2008–)2011Kun motor: B4164T, B4204T6, B4204T7
- Volvo V70 (2008–)2012–2014Kun motor: B4164T, B4164T2, B4204T7
- Volvo V70 (2008–)2015Kun motor: B4164T, B4164T2
- Volvo XC60 (2009–)2010Kun motor: B4204T6
- Volvo XC60 (2009–)2011–2012Kun motor: B4204T6, B4204T7
- Volvo XC60 (2009–)2013–2015Kun motor: B4204T7
Hva betyr feilkoden?
Although the code is named for a high signal, it concerns the rear oxygen sensor in bank 1, sensor 2, which does not show a rich mixture after the control module has changed the mixture. The engine control module (ECM) changes the mixture if the sensor does not register rich. At fuel cut-off the sensor should also show lean, and if the switch takes too long the code is set.
Mulige årsaker
- Leak in the exhaust system
- Damaged rear oxygen sensor
Hva du kan gjøre
- 1Read the code, clear it and road test the car to see whether it comes back
- 2Look for air leaks in the exhaust system, as a leak can give a wrong signal from the rear sensor
- 3Avoid rust solvent spray and grease in the rear sensor connector and check that it is fully engaged
- 4If no leak is found, replace the rear oxygen sensor; a damaged sensor can also set the code
Symptomer du kan merke1
- Check engine light (MIL) on
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.