VOLVO
ECM-P014500 - O2 Sensor Circuit Slow Response (Bank 1 Sensor 3). General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
8 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Vis modeller per årsmodell og motor (15)
- Volvo S60 (2011–)2014–2015Kun motor: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9
- Volvo S80 (2007–)2010Kun motor: B6324S2
- Volvo S80 (2007–)2011–2013Kun motor: B6324S4
- Volvo S80 (2007–)2014–2015Kun motor: B4204T11, B4204T12, B4204T15, B6324S4
- Volvo V40 (2013–)2015Kun motor: B4204T11
- Volvo V40 Cross Country (2013–)2015Kun motor: B4204T11
- Volvo V60 (2011–)2014–2015Kun motor: B4204T11, B4204T12, B4204T15, B4204T9
- Volvo V70 (2008–)2010Kun motor: B6324S2
- Volvo V70 (2008–)2014–2015Kun motor: B4204T11
- Volvo XC60 (2009–)2010Kun motor: B6324S2
- Volvo XC60 (2009–)2011–2013Kun motor: B6324S4
- Volvo XC60 (2009–)2014–2015Kun motor: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9, B6324S4
- Volvo XC70 (2008–)2010Kun motor: B6324S2
- Volvo XC70 (2008–)2011–2013Kun motor: B6324S4
- Volvo XC70 (2008–)2014–2015Kun motor: B4204T11, B6324S4
Hva betyr feilkoden?
The engine control module (ECM) measures how long the rear oxygen sensor in bank 1, sensor 3, takes to switch from rich to lean mixture. The code is set when the sensor reacts too slowly during a fuel cut-off. The test is only run once the engine is at operating temperature and after at least two longer fuel cut-offs in normal driving, and the code only applies to cars with three oxygen sensors.
Mulige årsaker
- Contact resistance or oxidation in the connections
- Damaged or dirty rear oxygen sensor, sensor 3
Hva du kan gjøre
- 1Read the code, clear it and road test the car to see whether it comes back
- 2Check the connector to the sensor for contact resistance and oxidation; do not use rust solvent spray or grease
- 3If you have a diagnostic tool: check in live data that the sensor signal follows the switches between rich and lean when the accelerator is released during a deceleration
- 4If the connector is clean and intact, replace the rear oxygen sensor
Symptomer du kan merke1
- Check engine light (MIL) on
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.