VOLVO
ECM-P015800 - O2 Circuit High Voltage (Bank 2, Sensor 2). General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
5 modellerS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Vis modeller per årsmodell og motor (13)
- Volvo S80 (2007–)2007–2010Kun motor: B6324S, B8444S
- Volvo S80 (2007–)2011Kun motor: B6324S5, B8444S
- Volvo S80 (2007–)2012–2015Kun motor: B6324S5
- Volvo V70 (2008–)2008–2010Kun motor: B6324S
- Volvo V70 (2008–)2011–2014Kun motor: B6324S5
- Volvo XC60 (2009–)2010Kun motor: B6324S
- Volvo XC60 (2009–)2011–2015Kun motor: B6324S5
- Volvo XC70 (2008–)2008–2010Kun motor: B6324S
- Volvo XC70 (2008–)2011–2015Kun motor: B6324S5
- Volvo XC90 (2003–)2005–2006Kun motor: B8444S
- Volvo XC90 (2003–)2007–2010Kun motor: B6324S, B8444S
- Volvo XC90 (2003–)2011Kun motor: B6324S5, B8444S
- Volvo XC90 (2003–)2012–2014Kun motor: B6324S5
Hva betyr feilkoden?
The engine control module (ECM) follows the signal from the rear oxygen sensor in bank 2, sensor 2, and sets the code when the limit values are not reached after a certain time, even though the heater has reached its values. The code concerns a high voltage in the signal from the rear sensor.
Mulige årsaker
- Signal wire shorted to supply voltage
- Damaged rear oxygen sensor
Hva du kan gjøre
- 1Read the code, clear it and road test the car to see whether it comes back
- 2Use a multimeter to check that the signal wire to the rear sensor has no contact with battery voltage
- 3Check the connector to the sensor; if it is clean and intact but the fault remains, replace the rear oxygen sensor
Symptomer du kan merke1
- Check engine light (MIL) on
Hva feilen kan påvirke1
- Control with the rear oxygen sensor is switched off
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.