Hva betyr feilkode ECM-P018A00?

Diagnose og feilkodedefinisjon for ECM-P018A00 (Volvo S60 (2011–), Volvo S80 (2007–), Volvo V40 (2013–)). Bestill reparasjon hos OBD Tuning.

VOLVO

ECM-P018A00 - Fuel Pressure Sensor "B" Circuit. General Failure Information. No sub type information

System

Motorstyring (ECM)

Volvo-modeller feilkoden gjelder for

Gjelder følgende modeller:

8 modeller

S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)

Vis modeller per årsmodell og motor (8)

Hva betyr feilkoden?

The control module (ECM) checks fuel pressure on the low-pressure side using the fuel pressure sensor, which is built into the same unit as the fuel temperature sensor. The code is set when pressure varies less than the limit allows, meaning the signal is not moving as it should. The fault may be caused by internal damage in the sensor.

Mulige årsaker

Internal fault in the fuel pressure sensor
Damaged fuel pressure sensor

Hva du kan gjøre

1Read and clear the code, then run the engine to see whether it returns
2Check the connector at the fuel pressure sensor for looseness, oxidation and damage
3If you have a diagnostic tool: read the fuel pressure in live data and check that the value changes when the engine is loaded
4If the fault remains after these checks, a workshop with diagnostic equipment should check the sensor

Symptomer du kan merke3

The Check engine lamp lights up or behaves abnormally
Poor performance and lack of power, especially when the car is pulling away
The engine hesitates, surges or runs unevenly on acceleration, when slowing down or at steady speed

Hva feilen kan påvirke1

The high-pressure fuel pump is switched off

Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.