VOLVO
ECM-P020600 - Cylinder 6 Injector Circuit / Open. General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
7 modellerS60 (2011–), S80 (2007–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Vis modeller per årsmodell og motor (24)
- Volvo S60 (2011–)2011–2014Kun motor: B6304T4
- Volvo S60 (2011–)2015Kun motor: B6304T3, B6304T4, B6304T5
- Volvo S80 (2007–)2007Kun motor: B6324S, B8444S
- Volvo S80 (2007–)2008–2009Kun motor: B6304T2, B6324S, B8444S
- Volvo S80 (2007–)2010Kun motor: B6304T2, B6324S, B6324S2, B8444S
- Volvo S80 (2007–)2011Kun motor: B6304T4, B6324S4, B6324S5, B8444S
- Volvo S80 (2007–)2012–2015Kun motor: B6304T4, B6324S4, B6324S5
- Volvo V60 (2011–)2011–2014Kun motor: B6304T4
- Volvo V60 (2011–)2015Kun motor: B6304T3, B6304T4, B6304T5
- Volvo V70 (2008–)2008–2009Kun motor: B6304T2, B6324S
- Volvo V70 (2008–)2010Kun motor: B6304T2, B6324S, B6324S2
- Volvo V70 (2008–)2011–2014Kun motor: B6304T4, B6324S5
- Volvo V70 (2008–)2015Kun motor: B6304T4
- Volvo XC60 (2009–)2009Kun motor: B6304T2
- Volvo XC60 (2009–)2010Kun motor: B6304T2, B6324S, B6324S2
- Volvo XC60 (2009–)2011–2015Kun motor: B6304T4, B6324S4, B6324S5
- Volvo XC70 (2008–)2008Kun motor: B6324S
- Volvo XC70 (2008–)2009Kun motor: B6304T2, B6324S
- Volvo XC70 (2008–)2010Kun motor: B6304T2, B6324S, B6324S2
- Volvo XC70 (2008–)2011–2015Kun motor: B6304T4, B6324S4, B6324S5
- Volvo XC90 (2003–)2005–2006Kun motor: B8444S
- Volvo XC90 (2003–)2007–2010Kun motor: B6324S, B8444S
- Volvo XC90 (2003–)2011Kun motor: B6324S5, B8444S
- Volvo XC90 (2003–)2012–2014Kun motor: B6324S5
Hva betyr feilkoden?
The control module (ECM) controls the injection timing for the injector on cylinder 6. The code is set when the control signal to the injector is out of range or absent, and lambda control is then blocked.
Mulige årsaker
- Contact resistance and oxidation in the injector connector
- Signal wire shorted to voltage
- Open circuit in the signal wire or the voltage supply wire
- Open circuit in the voltage supply wire
- Damaged injector
Hva du kan gjøre
- 1Check that the fuses are intact
- 2Read and clear the code, then start the engine to see whether it returns
- 3Check the connector to the injector on cylinder 6 for contact resistance and oxidation
- 4Use a multimeter to check that the wires to the injector on cylinder 6 have no break and are not shorted to voltage or earth
- 5If the fault remains, a workshop with diagnostic equipment should check the injector on cylinder 6 and the wires to it
Symptomer du kan merke5
- The environmental warning lamp lights up
- The engine does not run on all cylinders
- Cranking is fine, but the engine does not start
- The engine hesitates, surges or runs unevenly on acceleration or at steady speed
- Poor performance and lack of power
Hva feilen kan påvirke1
- Lambda control is blocked
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.