VOLVO
ECM-P023716 - Turbocharger/Supercharger Boost Sensor A Circuit Low. General Electrical Failures. Circuit voltage below threshold
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
7 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–)
Vis modeller per årsmodell og motor (20)
- Volvo S60 (2011–)2011Kun motor: B4164T, B4164T3, B4204T6, B4204T7
- Volvo S60 (2011–)2012–2014Kun motor: B4164T, B4164T2, B4164T3, B4204T7
- Volvo S60 (2011–)2015Kun motor: B4164T, B4164T2, B4164T3
- Volvo S80 (2007–)2010Kun motor: B4204T6
- Volvo S80 (2007–)2011Kun motor: B4164T, B4204T6, B4204T7
- Volvo S80 (2007–)2012–2014Kun motor: B4164T, B4164T2, B4204T6, B4204T7
- Volvo S80 (2007–)2015Kun motor: B4164T
- Volvo V40 (2013–)2013Kun motor: B4164T, B4164T3
- Volvo V40 (2013–)2014–2015Kun motor: B4164T, B4164T3, B4164T4
- Volvo V40 Cross Country (2013–)2013–2015Kun motor: B4164T
- Volvo V60 (2011–)2011Kun motor: B4164T, B4164T3, B4204T6, B4204T7
- Volvo V60 (2011–)2012–2014Kun motor: B4164T, B4164T2, B4164T3, B4204T7
- Volvo V60 (2011–)2015Kun motor: B4164T, B4164T2, B4164T3
- Volvo V70 (2008–)2010Kun motor: B4204T6
- Volvo V70 (2008–)2011Kun motor: B4164T, B4204T6, B4204T7
- Volvo V70 (2008–)2012–2014Kun motor: B4164T, B4164T2, B4204T7
- Volvo V70 (2008–)2015Kun motor: B4164T, B4164T2
- Volvo XC60 (2009–)2010Kun motor: B4204T6
- Volvo XC60 (2009–)2011–2012Kun motor: B4204T6, B4204T7
- Volvo XC60 (2009–)2013–2015Kun motor: B4204T7
Hva betyr feilkoden?
The engine control module (ECM) checks the boost pressure sensor signal. The fault is set when the signal stays below a certain value for a set time, and it concerns a voltage that is too low in the sensor circuit.
Mulige årsaker
- Contact resistance or oxidation in the connections
- Signal wire shorted to ground
- Damaged boost pressure sensor
Hva du kan gjøre
- 1Read the code, clear it and road test to see whether it returns
- 2Look at the boost pressure sensor connector for oxidation and loose connections
- 3Use a multimeter to check that the signal wire from the boost pressure sensor is not shorted to ground
- 4Check that the fuses are intact. Fuse locations are shown in the owner's manual
- 5If the fault remains, have a workshop check the boost pressure sensor with diagnostic equipment
Symptomer du kan merke2
- The check engine lamp comes on or behaves abnormally
- The car feels poor to drive, with reduced performance and lack of power
Hva feilen kan påvirke1
- Boost pressure is limited
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.