VOLVO
ECM-P024511 - Turbo/Super Charger Wastegate Solenoid A Low. General Electrical Failures. Circuit short to ground
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
7 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–)
Vis modeller per årsmodell og motor (20)
- Volvo S60 (2011–)2011Kun motor: B4164T, B4164T3, B4204T6, B4204T7
- Volvo S60 (2011–)2012–2014Kun motor: B4164T, B4164T2, B4164T3, B4204T7
- Volvo S60 (2011–)2015Kun motor: B4164T, B4164T2, B4164T3
- Volvo S80 (2007–)2010Kun motor: B4204T6
- Volvo S80 (2007–)2011Kun motor: B4164T, B4204T6, B4204T7
- Volvo S80 (2007–)2012–2014Kun motor: B4164T, B4164T2, B4204T6, B4204T7
- Volvo S80 (2007–)2015Kun motor: B4164T
- Volvo V40 (2013–)2013Kun motor: B4164T, B4164T3
- Volvo V40 (2013–)2014–2015Kun motor: B4164T, B4164T3, B4164T4
- Volvo V40 Cross Country (2013–)2013–2015Kun motor: B4164T
- Volvo V60 (2011–)2011Kun motor: B4164T, B4164T3, B4204T6, B4204T7
- Volvo V60 (2011–)2012–2014Kun motor: B4164T, B4164T2, B4164T3, B4204T7
- Volvo V60 (2011–)2015Kun motor: B4164T, B4164T2, B4164T3
- Volvo V70 (2008–)2010Kun motor: B4204T6
- Volvo V70 (2008–)2011Kun motor: B4164T, B4204T6, B4204T7
- Volvo V70 (2008–)2012–2014Kun motor: B4164T, B4164T2, B4204T7
- Volvo V70 (2008–)2015Kun motor: B4164T, B4164T2
- Volvo XC60 (2009–)2010Kun motor: B4204T6
- Volvo XC60 (2009–)2011–2012Kun motor: B4204T6, B4204T7
- Volvo XC60 (2009–)2013–2015Kun motor: B4204T7
Hva betyr feilkoden?
The signal wire to the turbo control valve has been shorted to ground, so the engine control module (ECM) registers too low a voltage on it. The fault is therefore an electrical one where the wire is shorted to ground.
Mulige årsaker
- Signal wire shorted to ground
- Damaged turbo control valve
Hva du kan gjøre
- 1Read the code, clear it and road test to see whether it returns
- 2With a diagnostic tool, activate the turbo control valve. A clear click from the engine bay shows that it works
- 3Look at the turbo control valve connector for contact resistance and oxidation
- 4Use a multimeter to check that the signal wire between the engine control module and the turbo control valve is not shorted to ground
- 5Check that the fuses are intact. Fuse locations are shown in the owner's manual
- 6If the fault remains, have a workshop check the turbo control valve with diagnostic equipment
Symptomer du kan merke2
- The check engine lamp comes on or behaves abnormally
- The car feels poor to drive, with reduced performance and lack of power
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.