VOLVO
ECM-P025A00 - Fuel Pump A Control Circuit / Open. General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
8 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Vis modeller per årsmodell og motor (8)
- Volvo S60 (2011–)2014–2015Kun motor: D4204T5
- Volvo S80 (2007–)2014–2015Kun motor: D4204T5
- Volvo V40 (2013–)2015Kun motor: D4204T14
- Volvo V40 Cross Country (2013–)2015Kun motor: D4204T14
- Volvo V60 (2011–)2014–2015Kun motor: D4204T5
- Volvo V70 (2008–)2014–2015Kun motor: D4204T5
- Volvo XC60 (2009–)2014–2015Kun motor: D4204T5
- Volvo XC70 (2008–)2014–2015Kun motor: D4204T5
Hva betyr feilkoden?
The ECM watches the control signal on its way to the PEM, the fuel pump control module. The code is stored when that signal is incorrect. The cause may be an open or short circuit in the wiring, or a fault in the fuel pump in the tank that gives too low pressure. The code is general and does not say what type of fault it is.
Mulige årsaker
- Open or short circuit in the wiring
- Fault in the fuel pump in the tank, giving too low pressure
Hva du kan gjøre
- 1Read and note the fault code, clear it and test drive to see whether it returns
- 2Check that the fuses are intact
- 3Check the connector to the fuel pump control module for contact resistance and oxidation
- 4With the ignition off, use a multimeter to check that the control wire to the pump control module has no open or short circuit
- 5Have a workshop with diagnostic equipment check the fuel pump in the tank and its control module
Symptomer du kan merke5
- The engine does not start but cranks
- The engine is hard to start and cranks slowly
- The car hesitates or surges during acceleration
- The engine stalls, at idle or while driving, at any time or all the time
- A message in the display together with a warning symbol
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.