Hva betyr feilkode ECM-P025D00?

Diagnose og feilkodedefinisjon for ECM-P025D00 (Volvo S60 (2011–), Volvo S80 (2007–), Volvo V40 (2013–)). Bestill reparasjon hos OBD Tuning.

VOLVO

ECM-P025D00 - Fuel Pump A Control Circuit High. General Failure Information. No sub type information

System

Motorstyring (ECM)

Volvo-modeller feilkoden gjelder for

Gjelder følgende modeller:

8 modeller

S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)

Vis modeller per årsmodell og motor (8)

Hva betyr feilkoden?

The ECM checks the signal heading to the PEM, which is the fuel pump control module. The code is stored when that signal is too high. The cause may be an open or short circuit in the wiring, or a fault in the fuel pump in the tank. The code is general and does not say what type of fault it is.

Mulige årsaker

Open or short circuit in the wiring
Fault in the fuel pump in the tank, which may give too low fuel pressure

Hva du kan gjøre

1Read and note the fault code, clear it and test drive to see whether it returns
2Check that the fuses are intact
3Check the connector to the fuel pump control module for contact resistance and oxidation
4With the ignition off and the engine control module connector disconnected, use a multimeter to check that the control signal wire has no open circuit or short circuit
5Have a workshop with diagnostic equipment check the fuel pump in the tank and its control module

Symptomer du kan merke5

The engine does not start but cranks
The engine is hard to start and cranks slowly
The car hesitates or surges during acceleration
The engine stalls, at idle or while driving, at any time or all the time
A message in the display together with a warning symbol

Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.