VOLVO
ECM-P027600 - Cylinder 6 Injector Circuit Low. General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
7 modellerS60 (2011–), S80 (2007–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Vis modeller per årsmodell og motor (10)
- Volvo S60 (2011–)2011–2014Kun motor: B6304T4
- Volvo S60 (2011–)2015Kun motor: B6304T3, B6304T4, B6304T5
- Volvo S80 (2007–)2011–2015Kun motor: B6304T4, B6324S4, B6324S5
- Volvo V60 (2011–)2011–2014Kun motor: B6304T4
- Volvo V60 (2011–)2015Kun motor: B6304T3, B6304T4, B6304T5
- Volvo V70 (2008–)2011–2014Kun motor: B6304T4, B6324S5
- Volvo V70 (2008–)2015Kun motor: B6304T4
- Volvo XC60 (2009–)2011–2015Kun motor: B6304T4, B6324S4, B6324S5
- Volvo XC70 (2008–)2011–2015Kun motor: B6304T4, B6324S4, B6324S5
- Volvo XC90 (2003–)2011–2014Kun motor: B6324S5
Hva betyr feilkoden?
The ECM controls injection timing and duration through the injectors and stores the code when the signal to the injector for cylinder 6 is too low. The code is general and does not say what type of fault it is. It applies to cylinder 6 only.
Mulige årsaker
- Contact resistance and oxidation in the connections
- Signal wire short-circuited to ground
- Damaged injector
Hva du kan gjøre
- 1Read and note the fault code, clear it and test drive to see whether it returns
- 2Check the connector to the cylinder 6 injector for contact resistance and oxidation
- 3With the ignition off and the connector disconnected, use a multimeter to check that the cylinder 6 signal wire is not short-circuited to ground
- 4Have a workshop with diagnostic equipment check the injector for cylinder 6 and its control
Symptomer du kan merke2
- The emissions warning lamp comes on
- The engine does not run on all cylinders
Hva feilen kan påvirke1
- The control module blocks lambda control
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.