VOLVO
ECM-P033664 - Crankshaft Position Sensor "A" Circuit Range/Performance. Algorithm Based Failures. Signal plausibility failure
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
8 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Vis modeller per årsmodell og motor (8)
- Volvo S60 (2011–)2014–2015Kun motor: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9
- Volvo S80 (2007–)2014–2015Kun motor: B4204T11, B4204T12, B4204T15
- Volvo V40 (2013–)2015Kun motor: B4204T11
- Volvo V40 Cross Country (2013–)2015Kun motor: B4204T11
- Volvo V60 (2011–)2014–2015Kun motor: B4204T11, B4204T12, B4204T15, B4204T9
- Volvo V70 (2008–)2014–2015Kun motor: B4204T11
- Volvo XC60 (2009–)2014–2015Kun motor: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9
- Volvo XC70 (2008–)2014–2015Kun motor: B4204T11
Hva betyr feilkoden?
The crankshaft position sensor signal gives the engine control module (ECM) information about crankshaft rotation. The fault is stored when the sensor does not register the gap that should be on the crankshaft, or when the number of teeth per revolution is wrong. The fault therefore concerns the signal's range and performance, and the code does not say which type of fault it is.
Mulige årsaker
- Contact resistance and oxidation in the connections
- Sensor fitted incorrectly
- Damaged crankshaft position sensor
Hva du kan gjøre
- 1If you have a diagnostic tool, start the engine, raise the engine speed a few times and read the fault status. 'Fault found' means the fault is permanent.
- 2Check that the fuses are intact.
- 3With the ignition off, check that the sensor connector is secure and free from oxidation and contact resistance.
- 4Check that the sensor is correctly fitted in the right position and that no cable with high current draw lies too close to it or its wiring.
- 5If you have a diagnostic tool, read the engine speed in live data when the engine starts. The value should rise steadily without jumping.
- 6If the fault returns, have a workshop check the flywheel reference holes.
Symptomer du kan merke4
- Check engine light is on or behaves abnormally
- Engine lacks power, especially when pulling away from standstill
- Car hesitates, jerks or runs roughly during acceleration or when slowing down
- Engine does not start, sometimes or every time
Hva feilen kan påvirke2
- The ECM may use the camshaft sensor signal instead
- Maximum engine speed is limited
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.