Hva betyr feilkode ECM-P034211?

Diagnose og feilkodedefinisjon for ECM-P034211 (Volvo S60 (2011–), Volvo S60 (2011–), Volvo S60 (2011–)). Bestill reparasjon hos OBD Tuning.

VOLVO

ECM-P034211 - Camshaft Position Sensor A Circuit Low (Bank 1 or single sensor). General Electrical Failures. Circuit short to ground

System

Motorstyring (ECM)

Volvo-modeller feilkoden gjelder for

Gjelder følgende modeller:

7 modeller

S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–)

Vis modeller per årsmodell og motor (20)

Hva betyr feilkoden?

The camshaft sensor signal is a PWM signal, and the engine control module (ECM) checks it while the engine runs. The fault is stored when the signal stays constantly low, which can be caused by a short to ground in the signal wire. The code applies to the intake camshaft sensor on bank 1, or to the single sensor if the engine has only one.

Mulige årsaker

Signal wire short circuit to ground
Open circuit in the supply wire
Loose connections

Hva du kan gjøre

1If you have a diagnostic tool, start the engine and read the fault status. 'Fault found' means the fault is permanent.
2Check that the fuses are intact.
3Use a multimeter to check that the signal wire to the camshaft sensor does not touch ground or the body.
4Use a multimeter to check that the supply wire to the camshaft sensor is not broken.
5Check that the connector at the camshaft sensor is secure, since loose connections can cause this code.
6If the fault returns, have a workshop check the wiring between the camshaft sensor and the control module.

Symptomer du kan merke2

Engine does not start, sometimes or every time
Engine is hard to start and cranks slowly

Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.