VOLVO
ECM-P035500 - Ignition Coil E Primary/Secondary Circuit. General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
6 modellerS60 (2011–), S80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Vis modeller per årsmodell og motor (19)
- Volvo S60 (2011–)2011–2012Kun motor: B5254T5
- Volvo S80 (2007–)2007Alle motorer unntatt: D5244T4, D5244T5
- Volvo S80 (2007–)2008Kun motor: B5254T6, B6304T2, B6324S, B8444S
- Volvo S80 (2007–)2009Kun motor: B5254T6, B5254T8, B6304T2, B6324S, B8444S
- Volvo S80 (2007–)2010Kun motor: B5254T10, B5254T11, B5254T8, B6304T2, B6324S, B6324S2, B8444S
- Volvo S80 (2007–)2011Kun motor: B5254T10, B5254T11, B5254T8, B8444S
- Volvo S80 (2007–)2012Kun motor: B5254T10
- Volvo V70 (2008–)2008Kun motor: B5254T6, B6304T2, B6324S
- Volvo V70 (2008–)2009Kun motor: B5254T6, B5254T8, B6304T2, B6324S
- Volvo V70 (2008–)2010Kun motor: B5254T10, B5254T11, B6304T2, B6324S, B6324S2
- Volvo V70 (2008–)2011Kun motor: B5254T10, B5254T11
- Volvo V70 (2008–)2012Kun motor: B5254T10
- Volvo XC60 (2009–)2009Kun motor: B6304T2
- Volvo XC60 (2009–)2010Kun motor: B6304T2, B6324S, B6324S2
- Volvo XC70 (2008–)2008Kun motor: B6324S
- Volvo XC70 (2008–)2009Kun motor: B6304T2, B6324S
- Volvo XC70 (2008–)2010Kun motor: B6304T2, B6324S, B6324S2
- Volvo XC90 (2003–)2005–2006, 2011Kun motor: B8444S
- Volvo XC90 (2003–)2007–2010Kun motor: B6324S, B8444S
Hva betyr feilkoden?
The code applies to ignition coil E, which is the coil for cylinder 5. It shows which coil is affected but not which type of fault it is. The engine control module (ECM) checks the coils' function through a separate diagnostic line.
Mulige årsaker
- Contact resistance and oxidation at the coil connector
- Signal wire short circuit to ground or supply voltage
- Open circuit in the signal wire
- Open circuit in the supply wire
- Diagnostic line short circuit to ground or supply voltage
- Damaged ignition coil
Hva du kan gjøre
- 1If you have a diagnostic tool, start the engine and read the fault status. 'No fault found' means the fault is not active right now.
- 2Check that the fuses are intact.
- 3With the ignition off, check the connector to the ignition coil for cylinder 5 for contact resistance and oxidation.
- 4Use a multimeter to check that the wires to the ignition coil for cylinder 5 have no open circuit and are not shorted to ground or supply voltage.
- 5Check that the ignition coil is secure and not damaged.
- 6If the fault returns, have a workshop check the ignition coil for cylinder 5 and its diagnostic line.
Symptomer du kan merke5
- Engine misfires
- Check engine light (emissions warning lamp) is on
- Engine is not firing on all cylinders
- Car lacks power, especially when pulling away from standstill
- Car hesitates or jerks when slowing down
Hva feilen kan påvirke1
- Closed loop control of lambda is blocked
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.