VOLVO
ECM-P035513 - Ignition Coil E Primary/Secondary Circuit. General Electrical Failures. Circuit open
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
10 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Vis modeller per årsmodell og motor (20)
- Volvo S60 (2011–)2011–2012Kun motor: B6304T4
- Volvo S60 (2011–)2013–2014Kun motor: B5204T8, B5204T9, B5254T12, B5254T14, B6304T4
- Volvo S60 (2011–)2015Kun motor: B5204T8, B5204T9, B5254T12, B5254T14, B6304T3, B6304T4, B6304T5
- Volvo S80 (2007–)2011–2012, 2015Kun motor: B6304T4, B6324S4, B6324S5
- Volvo S80 (2007–)2013–2014Kun motor: B5254T12, B5254T14, B6304T4, B6324S4, B6324S5
- Volvo V40 (2013–)2013–2014Kun motor: B5204T8, B5204T9, B5254T12, B5254T14
- Volvo V40 (2013–)2015Kun motor: B5204T8, B5204T9
- Volvo V40 Cross Country (2013–)2013–2015Kun motor: B5204T8, B5204T9, B5254T12, B5254T14
- Volvo V60 (2011–)2011–2012Kun motor: B6304T4
- Volvo V60 (2011–)2013Kun motor: B5204T8, B5204T9, B6304T4
- Volvo V60 (2011–)2014Kun motor: B5204T8, B5204T9, B5254T12, B6304T4
- Volvo V60 (2011–)2015Kun motor: B5204T9, B5254T12, B6304T3, B6304T4, B6304T5
- Volvo V60 Cross Country (2015–)2015
- Volvo V70 (2008–)2011–2012Kun motor: B6304T4, B6324S5
- Volvo V70 (2008–)2013–2014Kun motor: B5204T9, B6304T4, B6324S5
- Volvo V70 (2008–)2015Kun motor: B5204T9, B6304T4
- Volvo XC60 (2009–)2011–2014Kun motor: B6304T4, B6324S4, B6324S5
- Volvo XC60 (2009–)2015Kun motor: B5204T9, B5254T12, B5254T14, B6304T4, B6324S4, B6324S5
- Volvo XC70 (2008–)2011–2015Kun motor: B6304T4, B6324S4, B6324S5
- Volvo XC90 (2003–)2011–2014Kun motor: B6324S5
Hva betyr feilkoden?
Ignition coil E has an open circuit in its signal wire, according to the code. The code is stored when the open circuit persists over several driving cycles in a row, and it concerns the primary and secondary circuit of the coil.
Mulige årsaker
- Contact resistance and oxidation in the connections
- Open circuit in the signal wire
- Damaged ignition coil
Hva du kan gjøre
- 1If you have a diagnostic tool, start the engine and read the fault status. 'Fault found' means the fault is permanent.
- 2Check that the fuses are intact.
- 3With the ignition off, check the connector at ignition coil E for contact resistance and oxidation.
- 4Use a multimeter to check that the signal wire to ignition coil E has no open circuit.
- 5Check that the wire to ignition coil E is not twisted, pinched or chafed.
- 6If the fault returns, have a workshop check ignition coil E and its diagnostic line.
Symptomer du kan merke4
- Engine lacks power, especially when pulling away from standstill
- Car lacks power while driving
- Car hesitates or jerks during acceleration
- Car hesitates or jerks at steady speed
Hva feilen kan påvirke1
- Closed loop control of lambda is blocked
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.