VOLVO
ECM-P057900 - Cruise Control Multi-Function Input A Circuit Range/Performance. General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
5 modellerS60 (2011–), S80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Vis modeller per årsmodell og motor (13)
- Volvo S60 (2011–)2011–2012Kun motor: B5254T5
- Volvo S80 (2007–)2007–2008Kun motor: B5254T6
- Volvo S80 (2007–)2009Kun motor: B5254T6, B5254T8, D5244T10
- Volvo S80 (2007–)2010Kun motor: B5254T10, B5254T11, B5254T8, D5244T10, D5244T14, D5244T19
- Volvo S80 (2007–)2011Kun motor: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Kun motor: B5254T10
- Volvo V70 (2008–)2008Kun motor: B5254T6
- Volvo V70 (2008–)2009Kun motor: B5254T6, B5254T8, D5244T10
- Volvo V70 (2008–)2010Kun motor: B5254T10, B5254T11, D5244T10, D5244T14, D5244T19
- Volvo V70 (2008–)2011Kun motor: B5254T10, B5254T11
- Volvo V70 (2008–)2012Kun motor: B5254T10
- Volvo XC60 (2009–)2010Kun motor: D5244T10, D5244T14, D5244T16
- Volvo XC70 (2008–)2010Kun motor: D5244T10, D5244T14, D5244T16
Hva betyr feilkoden?
The ECM receives the signal from the front monitoring module (FSM) over the CAN network. The fault is stored when the signal from the FSM is faulty, and The code is also set by a CAN communication fault, or by a fault in the steering wheel module, the central electronics module, the brake control module or the transmission control module.
Mulige årsaker
- Open circuit in one of the CAN wires
- Short circuit between the CAN wires
- Internal fault in the ECM itself
- Temporary breaks or interference on one or both CAN wires on part of the network
- Contact resistance, oxidation or open circuit in connections
- The ECM is not intended for this car, for example a used module with different software or hardware
Hva du kan gjøre
- 1Check that the fuses are intact
- 2If you have diagnostic equipment: read the CEM and other affected module fault codes, deal with them first, then clear this code
- 3If you have diagnostic equipment: read the fault codes in the front monitoring module (FSM)
- 4Check that the connectors on the CAN network are firmly seated and not corroded
- 5Use a multimeter to check that the CAN wires have no open circuit or short to each other
- 6If nothing is found, have a workshop check the CAN network and that the engine control module is intended for this particular car
Symptomer du kan merke2
- Cruise control does not work at all
- Cruise control does not engage
Hva feilen kan påvirke2
- Cruise control is switched off
- Cruise control cannot be activated
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.