VOLVO
ECM-P058185 - Cruise Control Multi-Function Input A Circuit High. Bus Signal / Message Failures. Signal above allowable range
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
4 modellerS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Vis modeller per årsmodell og motor (6)
- Volvo S80 (2007–)2009Kun motor: D5244T10
- Volvo S80 (2007–)2010Kun motor: D5244T10, D5244T14, D5244T19
- Volvo V70 (2008–)2009Kun motor: D5244T10
- Volvo V70 (2008–)2010Kun motor: D5244T10, D5244T14, D5244T19
- Volvo XC60 (2009–)2010Kun motor: D5244T10, D5244T14, D5244T16
- Volvo XC70 (2008–)2010Kun motor: D5244T10, D5244T14, D5244T16
Hva betyr feilkoden?
The ECM receives information from the front monitoring module (FSM) over the CAN network. The fault is stored when the signal from the FSM is above what is allowed, and it is tested with the ignition on.
Mulige årsaker
- The fault may lie in the front monitoring module (FSM)
- Breaks or interference on the CAN wires
- Contact resistance, oxidation or open circuit in connections
- The ECM is not intended for this car, for example a used module with different software or hardware
Hva du kan gjøre
- 1Check that the fuses are intact
- 2If you have diagnostic equipment: read the fault codes in the front monitoring module (FSM) and deal with them first
- 3Check that the connectors on the CAN network and to the FSM are firmly seated and not corroded
- 4Use a multimeter to check that the CAN wires have no open circuit or short to ground or supply voltage
- 5If the fault remains, have a workshop check the CAN network and that the correct engine control module is fitted for this car
Symptomer du kan merke1
- Cruise control does not engage
Hva feilen kan påvirke2
- The cruise control function is switched off
- Cruise control cannot be activated
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.