VOLVO
ECM-P061616 - Starter Relay Circuit Low. General Electrical Failures. Circuit voltage below threshold
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
8 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Vis modeller per årsmodell og motor (23)
- Volvo S60 (2011–)2012Kun motor: D5204T3, D5244T11, D5244T15
- Volvo S60 (2011–)2013–2014Kun motor: D5204T3, D5204T7, D5244T11, D5244T15
- Volvo S60 (2011–)2015Kun motor: D5204T3, D5204T7, D5244T11, D5244T15, D5244T23
- Volvo S80 (2007–)2012Kun motor: D5204T3, D5244T11, D5244T15
- Volvo S80 (2007–)2013–2014Kun motor: D5204T3, D5204T7, D5244T11, D5244T15
- Volvo S80 (2007–)2015Kun motor: D5204T3, D5244T15
- Volvo V40 (2013–)2013–2014Kun motor: D5204T4, D5204T6
- Volvo V40 (2013–)2015Kun motor: D5204T6
- Volvo V40 Cross Country (2013–)2013–2014Kun motor: D5204T4, D5204T6
- Volvo V40 Cross Country (2013–)2015Kun motor: D5204T6
- Volvo V60 (2011–)2012Kun motor: D5204T3, D5244T11, D5244T15
- Volvo V60 (2011–)2013Kun motor: D5204T3, D5204T7, D5244T11, D5244T15, D5244T17, D82PHEV
- Volvo V60 (2011–)2014Kun motor: D5204T3, D5204T7, D5244T11, D5244T12, D5244T15, D5244T17, D82PHEV
- Volvo V60 (2011–)2015Kun motor: D5204T3, D5204T7, D5244T11, D5244T12, D5244T15, D5244T17, D5244T23, D82PHEV, D87PHEV
- Volvo V70 (2008–)2012Kun motor: D5204T3, D5244T11, D5244T15
- Volvo V70 (2008–)2013Kun motor: D5204T3, D5204T7, D5244T11, D5244T15, D5244T17
- Volvo V70 (2008–)2014–2015Kun motor: D5204T3, D5204T7, D5244T11, D5244T12, D5244T15, D5244T17
- Volvo XC60 (2009–)2012Kun motor: D5204T3, D5244T11, D5244T15, D5244T17
- Volvo XC60 (2009–)2013Alle motorer unntatt: B4204T7, B6304T4, B6324S4, B6324S5
- Volvo XC60 (2009–)2014Kun motor: D5204T3, D5204T7, D5244T11, D5244T12, D5244T15, D5244T17
- Volvo XC60 (2009–)2015Kun motor: D5204T3, D5204T7, D5244T11, D5244T12, D5244T15, D5244T17, D5244T23
- Volvo XC70 (2008–)2012–2013Alle motorer unntatt: B6304T4, B6324S4, B6324S5
- Volvo XC70 (2008–)2014–2015Kun motor: D5204T3, D5244T11, D5244T12, D5244T15, D5244T17
Hva betyr feilkoden?
The engine control module (ECM) has found a fault in the HS line that drives the starter through the start relay, and the voltage on that signal cable is too low. While the fault is active, the engine may start poorly or not at all, and automatic start/stop does not work.
Mulige årsaker
- The signal cable to the start relay is short-circuited to ground
Hva du kan gjøre
- 1Check that the fuses for the starting system are intact
- 2With the ignition off, check that the connectors at the start relay and the control module are secure and free from corrosion and oxidation
- 3Look for chafed or pinched wiring in the signal cable to the start relay, especially where it may touch the body
- 4Use a multimeter to check that the signal cable to the start relay has no contact with ground (the body)
- 5If you have a diagnostic tool: activate the start relay and listen for it to click, then read the fault code again
- 6If the wiring is intact and the connectors are good but the fault remains: have a workshop check the start relay and the control module
Symptomer du kan merke3
- The engine does not start, either occasionally or all the time
- Automatic start/stop of the engine does not work while driving
- Automatic start/stop of the engine does not work at idle
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.