VOLVO
ECM-P068611 - ECM/PCM Power Relay Control Circuit Low. General Electrical Failures. Circuit short to ground
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
7 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–)
Vis modeller per årsmodell og motor (20)
- Volvo S60 (2011–)2011Kun motor: B4164T, B4164T3, B4204T6, B4204T7
- Volvo S60 (2011–)2012–2014Kun motor: B4164T, B4164T2, B4164T3, B4204T7
- Volvo S60 (2011–)2015Kun motor: B4164T, B4164T2, B4164T3
- Volvo S80 (2007–)2010Kun motor: B4204T6
- Volvo S80 (2007–)2011Kun motor: B4164T, B4204T6, B4204T7
- Volvo S80 (2007–)2012–2014Kun motor: B4164T, B4164T2, B4204T6, B4204T7
- Volvo S80 (2007–)2015Kun motor: B4164T
- Volvo V40 (2013–)2013Kun motor: B4164T, B4164T3
- Volvo V40 (2013–)2014–2015Kun motor: B4164T, B4164T3, B4164T4
- Volvo V40 Cross Country (2013–)2013–2015Kun motor: B4164T
- Volvo V60 (2011–)2011Kun motor: B4164T, B4164T3, B4204T6, B4204T7
- Volvo V60 (2011–)2012–2014Kun motor: B4164T, B4164T2, B4164T3, B4204T7
- Volvo V60 (2011–)2015Kun motor: B4164T, B4164T2, B4164T3
- Volvo V70 (2008–)2010Kun motor: B4204T6
- Volvo V70 (2008–)2011Kun motor: B4164T, B4204T6, B4204T7
- Volvo V70 (2008–)2012–2014Kun motor: B4164T, B4164T2, B4204T7
- Volvo V70 (2008–)2015Kun motor: B4164T, B4164T2
- Volvo XC60 (2009–)2010Kun motor: B4204T6
- Volvo XC60 (2009–)2011–2012Kun motor: B4204T6, B4204T7
- Volvo XC60 (2009–)2013–2015Kun motor: B4204T7
Hva betyr feilkoden?
When the ignition goes off, the system relay releases only after a set delay, which gives the control module time to finish what it is doing before power to the affected parts is removed. The code is set when the relay releases too late or too early compared with what is expected.
Mulige årsaker
- Signal wire short-circuited to ground
- No supply voltage to the system relay
- Damaged system relay
Hva du kan gjøre
- 1Read and clear the fault code, and check the battery charge and that the terminals are secure
- 2Check the fuses for the system relay supply in the owner's manual
- 3Look at the wiring to the system relay for chafing, pinch damage and loose contacts, especially where it may have touched the body
- 4Use a multimeter to check that the signal wire to the system relay has no contact with ground (the body), with the connectors disconnected
- 5Check that supply voltage reaches the relay: measure at the connector with the ignition on
- 6If the fault remains after these checks, have a workshop check the system relay
Symptomer du kan merke2
- The battery may appear weak
- The vehicle electrical system may have lower voltage than normal
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.