VOLVO
ECM-P080800 - Clutch Position Sensor "A" Circuit High. General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Feilkoden har ulik betydning avhengig av modell, årsmodell eller motor. Velg betydningen som gjelder din bil.
Gjelder følgende modeller:
6 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–)
Vis modeller per årsmodell og motor (6)
Hva betyr feilkoden?
The engine control module (ECM) keeps watch on the clutch pedal with the position sensor and checks it against the pedal switch. The code is set when the position sensor signal, sent over CAN, lies above the permitted range for longer than allowed.
Mulige årsaker
- Loose contact, oxidation or contact resistance in the connector
- Damaged signal wire
- Damaged clutch pedal sensor
- Damaged clutch pedal position sensor
Hva du kan gjøre
- 1Check that the fuses are intact. The locations are shown in the instruction manual or on the fuse list
- 2Try starting, auto-start and automatic stop-start with the buttons and controls to see whether the symptoms can be reproduced
- 3Read off and note the fault code, erase it and take the car for a test drive to see whether it returns
- 4Check that the connectors at the position sensor and pedal switch are firmly seated and free from oxidation
- 5Check that the wiring to the position sensor has no chafing, crush damage or loose clips, especially where the cable moves
- 6If you have a diagnostic tool, read live data for the position sensor while pressing and releasing the pedal, and check that the value follows the pedal movement
Symptomer du kan merke3
- Starting and auto-start do not work
- Automatic engine stop-start does not work, both at idle and while driving
- The car may hesitate, surge or run jerkily while driving, even at constant speed
Hva feilen kan påvirke1
- The automatic engine stop-start function is switched off
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.