VOLVO
ECM-P085000 - Park / Neutral Switch Input Circuit. General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
3 modellerS60 (2011–), S80 (2007–), V70 (2008–)
Vis modeller per årsmodell og motor (9)
- Volvo S60 (2011–)2011–2012Kun motor: B5254T5
- Volvo S80 (2007–)2007–2008Kun motor: B5254T6
- Volvo S80 (2007–)2009Kun motor: B5254T6, B5254T8
- Volvo S80 (2007–)2010–2011Kun motor: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Kun motor: B5254T10
- Volvo V70 (2008–)2008Kun motor: B5254T6
- Volvo V70 (2008–)2009Kun motor: B5254T6, B5254T8
- Volvo V70 (2008–)2010–2011Kun motor: B5254T10, B5254T11
- Volvo V70 (2008–)2012Kun motor: B5254T10
Hva betyr feilkoden?
The ECM compares the park and neutral gear positions on the direct wire with the same positions received over CAN. The code is set when the two signals do not agree.
Mulige årsaker
- Signal wire shorted to earth or to voltage
- Break in the signal wire
- The root cause is in the transmission control module (TCM)
Hva du kan gjøre
- 1Read the fault codes in the transmission control module (TCM). If a fault code for the gear position is stored there, remedy it first
- 2Check that the fuses are intact. The locations are shown in the instruction manual or on the fuse list
- 3Check the connector at the transmission control module (TCM) for contact resistance and oxidation
- 4Use a multimeter to check that the signal wire has no break and no contact with earth or voltage
- 5If the fault remains after these checks, have a workshop investigate the transmission control module (TCM)
Symptomer du kan merke1
- The starter motor does not engage the engine
Hva feilen kan påvirke1
- The ECM uses the signal received over CAN instead
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.