VOLVO
ECM-P116922 - Fuel Rail Pressure Sensor In Range But High. General Signal Failures. Signal too high
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
7 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–)
Vis modeller per årsmodell og motor (20)
- Volvo S60 (2011–)2011Kun motor: B4164T, B4164T3, B4204T6, B4204T7
- Volvo S60 (2011–)2012–2014Kun motor: B4164T, B4164T2, B4164T3, B4204T7
- Volvo S60 (2011–)2015Kun motor: B4164T, B4164T2, B4164T3
- Volvo S80 (2007–)2010Kun motor: B4204T6
- Volvo S80 (2007–)2011Kun motor: B4164T, B4204T6, B4204T7
- Volvo S80 (2007–)2012–2014Kun motor: B4164T, B4164T2, B4204T6, B4204T7
- Volvo S80 (2007–)2015Kun motor: B4164T
- Volvo V40 (2013–)2013Kun motor: B4164T, B4164T3
- Volvo V40 (2013–)2014–2015Kun motor: B4164T, B4164T3, B4164T4
- Volvo V40 Cross Country (2013–)2013–2015Kun motor: B4164T
- Volvo V60 (2011–)2011Kun motor: B4164T, B4164T3, B4204T6, B4204T7
- Volvo V60 (2011–)2012–2014Kun motor: B4164T, B4164T2, B4164T3, B4204T7
- Volvo V60 (2011–)2015Kun motor: B4164T, B4164T2, B4164T3
- Volvo V70 (2008–)2010Kun motor: B4204T6
- Volvo V70 (2008–)2011Kun motor: B4164T, B4204T6, B4204T7
- Volvo V70 (2008–)2012–2014Kun motor: B4164T, B4164T2, B4204T7
- Volvo V70 (2008–)2015Kun motor: B4164T, B4164T2
- Volvo XC60 (2009–)2010Kun motor: B4204T6
- Volvo XC60 (2009–)2011–2012Kun motor: B4204T6, B4204T7
- Volvo XC60 (2009–)2013–2015Kun motor: B4204T7
Hva betyr feilkoden?
The ECM monitors the high pressure side of the fuel system through the pressure sensor. The code is set when fuel pressure builds up too quickly during pre-heating, or when the fuel adaptations indicate rich running under pressure above a certain level, if the block heater was not running at start.
Mulige årsaker
- Leak in the fuel system
- Damaged fuel pressure sensor
Hva du kan gjøre
- 1Look for leaks on the high pressure side of the fuel system and fix any faults
- 2Check other fault codes in the control module that could affect the fuel system before replacing any part
- 3Note the engine and ambient temperatures when the fault occurs, since this helps the workshop
- 4If you find no leak or other fault codes: have a workshop replace the high pressure fuel pressure sensor
- 5If the fault returns after repair: have a workshop check the high pressure fuel pump
Symptomer du kan merke3
- Idle that stalls, either occasionally or all the time
- Poor performance and lack of power while driving
- The engine is hard to start or does not start, either occasionally or all the time
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.