Hva betyr feilkode ECM-P128200?

Diagnose og feilkodedefinisjon for ECM-P128200 (Volvo S60 (2011–), Volvo S80 (2007–), Volvo V40 (2013–)). Bestill reparasjon hos OBD Tuning.

VOLVO

ECM-P128200 - Injector Control Pressure Higher Than Desired (engine running). General Failure Information. No sub type information

System

Motorstyring (ECM)

Volvo-modeller feilkoden gjelder for

Gjelder følgende modeller:

8 modeller

S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)

Vis modeller per årsmodell og motor (8)

Hva betyr feilkoden?

The engine control module (ECM) compares the fuel pressure on the high pressure side of the fuel system with the largest permitted deviation above the correct pressure. The correct pressure depends on engine load and speed. The check is only made with the engine running, and the code is set when the deviation is greater than permitted. It gives no further fault type.

Mulige årsaker

The fuel flow control valve is damaged
The fuel pressure control valve is damaged
Air in the fuel system
Too high back pressure on the return side of the fuel system

Hva du kan gjøre

1Check the fuel level in the tank and top up if it is low.
2Look for leaks in the fuel system, such as wet spots or a smell of fuel at pipes and connections under the car.
3Deal with any fault codes for the fuel pump first.
4If you have a diagnostic tool, compare the measured and requested fuel pressure in live data at idle and at light throttle. The values should be close to each other.
5Have a workshop check the control valves, injector leakage, the fuel filter and the fuel pressure sensor wiring, as this needs measurements.

Symptomer du kan merke1

Unusual noise while driving

Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.