VOLVO
ECM-P130068 - Boost Calibration Fault. Algorithm Based Failures. Event information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
5 modellerS60 (2011–), S80 (2007–), V60 (2011–), V70 (2008–), XC60 (2009–)
Vis modeller per årsmodell og motor (12)
- Volvo S60 (2011–)2011Kun motor: B4204T6, B4204T7
- Volvo S60 (2011–)2012–2014Kun motor: B4204T7
- Volvo S80 (2007–)2010Kun motor: B4204T6
- Volvo S80 (2007–)2011–2014Kun motor: B4204T6, B4204T7
- Volvo V60 (2011–)2011Kun motor: B4204T6, B4204T7
- Volvo V60 (2011–)2012–2014Kun motor: B4204T7
- Volvo V70 (2008–)2010Kun motor: B4204T6
- Volvo V70 (2008–)2011Kun motor: B4204T6, B4204T7
- Volvo V70 (2008–)2012–2014Kun motor: B4204T7
- Volvo XC60 (2009–)2010Kun motor: B4204T6
- Volvo XC60 (2009–)2011–2012Kun motor: B4204T6, B4204T7
- Volvo XC60 (2009–)2013–2015Kun motor: B4204T7
Hva betyr feilkoden?
This is an event-controlled information code. It does not indicate a fault in the engine control module but is intended as information, and it disappears by itself when the conditions no longer apply. The module compares the measured boost pressure with its target value. The code is set when the boost pressure is higher than the target, at high engine speed and high engine load.
Mulige årsaker
- Incorrect adjustment of the wastegate valve pressure servo
- Sticking wastegate valve
- Damaged turbocharger control valve
Hva du kan gjøre
- 1Read the codes and note which others are stored. This code is a knock-on fault, so the other faults should be dealt with first.
- 2Do not clear the code in advance. It does not need clearing and disappears when the conditions no longer apply, but you can clear it once the other faults are dealt with.
- 3If the code is still present after that, have a workshop with diagnostic equipment check the wastegate valve and the turbocharger control valve.
Symptomer du kan merke1
- No noticeable symptoms for the driver
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.